From d447df140d0f07a02bd221cb42eb0b61bce16042 Mon Sep 17 00:00:00 2001 From: Tejun Heo Date: Sun, 18 Mar 2007 22:15:33 +0900 Subject: [PATCH] ahci: implement ata_save/restore_initial_config() There are several registers which describe how the controller is configured. These registers are sometimes implemented as r/w registers which are configured by firmware and get cleared on controller reset or after suspend/resume cycle. ahci saved and restored those values inside ahci_reset_controller() which is a bit messy and doesn't work over suspend/resume cycle. This patch implements ahci_save/restore_initial_config(). The save function is called during driver initialization and saves cap and port_map to hpriv. The restore function is called after the controller is reset to restore the initial values. Sometimes the initial firmware values are inconsistent and need to be fixed up. This is handled by ahci_save_initial_config(). For this, there are two versions of saved registers. One to write back to the hardware register, the other to use during driver operation. This is necessary to keep ahci's behavior unchanged (write back fixed up port_map while keeping cap as-is). This patch makes ahci save the register values once before the first controller reset, not after it's been reset. Also, the same stored values are used written back after each reset, so the register values are properly recovered after suspend/resume cycle. Signed-off-by: Tejun Heo Signed-off-by: Jeff Garzik --- drivers/ata/ahci.c | 95 +++++++++++++++++++++++++++++++++++----------- 1 file changed, 72 insertions(+), 23 deletions(-) diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c index fd27227771..c31b663663 100644 --- a/drivers/ata/ahci.c +++ b/drivers/ata/ahci.c @@ -188,8 +188,10 @@ struct ahci_sg { }; struct ahci_host_priv { - u32 cap; /* cache of HOST_CAP register */ - u32 port_map; /* cache of HOST_PORTS_IMPL reg */ + u32 cap; /* cap to use */ + u32 port_map; /* port map to use */ + u32 saved_cap; /* saved initial cap */ + u32 saved_port_map; /* saved initial port_map */ }; struct ahci_port_priv { @@ -477,6 +479,65 @@ static inline void __iomem *ahci_port_base(void __iomem *base, return base + 0x100 + (port * 0x80); } +/** + * ahci_save_initial_config - Save and fixup initial config values + * @probe_ent: probe_ent of target device + * + * Some registers containing configuration info might be setup by + * BIOS and might be cleared on reset. This function saves the + * initial values of those registers into @hpriv such that they + * can be restored after controller reset. + * + * If inconsistent, config values are fixed up by this function. + * + * LOCKING: + * None. + */ +static void ahci_save_initial_config(struct ata_probe_ent *probe_ent) +{ + struct ahci_host_priv *hpriv = probe_ent->private_data; + void __iomem *mmio = probe_ent->iomap[AHCI_PCI_BAR]; + u32 cap, port_map; + + /* Values prefixed with saved_ are written back to host after + * reset. Values without are used for driver operation. + */ + hpriv->saved_cap = cap = readl(mmio + HOST_CAP); + hpriv->saved_port_map = port_map = readl(mmio + HOST_PORTS_IMPL); + + /* fixup zero port_map */ + if (!port_map) { + port_map = (1 << ahci_nr_ports(hpriv->cap)) - 1; + dev_printk(KERN_WARNING, probe_ent->dev, + "PORTS_IMPL is zero, forcing 0x%x\n", port_map); + + /* write the fixed up value to the PI register */ + hpriv->saved_port_map = port_map; + } + + /* record values to use during operation */ + hpriv->cap = cap; + hpriv->port_map = port_map; +} + +/** + * ahci_restore_initial_config - Restore initial config + * @mmio: MMIO base for the host + * @hpriv: host private data + * + * Restore initial config stored by ahci_save_initial_config(). + * + * LOCKING: + * None. + */ +static void ahci_restore_initial_config(void __iomem *mmio, + struct ahci_host_priv *hpriv) +{ + writel(hpriv->saved_cap, mmio + HOST_CAP); + writel(hpriv->saved_port_map, mmio + HOST_PORTS_IMPL); + (void) readl(mmio + HOST_PORTS_IMPL); /* flush */ +} + static u32 ahci_scr_read (struct ata_port *ap, unsigned int sc_reg_in) { unsigned int sc_reg; @@ -653,12 +714,10 @@ static int ahci_deinit_port(void __iomem *port_mmio, u32 cap, const char **emsg) return 0; } -static int ahci_reset_controller(void __iomem *mmio, struct pci_dev *pdev) +static int ahci_reset_controller(void __iomem *mmio, struct pci_dev *pdev, + struct ahci_host_priv *hpriv) { - u32 cap_save, impl_save, tmp; - - cap_save = readl(mmio + HOST_CAP); - impl_save = readl(mmio + HOST_PORTS_IMPL); + u32 tmp; /* global controller reset */ tmp = readl(mmio + HOST_CTL); @@ -683,18 +742,8 @@ static int ahci_reset_controller(void __iomem *mmio, struct pci_dev *pdev) writel(HOST_AHCI_EN, mmio + HOST_CTL); (void) readl(mmio + HOST_CTL); /* flush */ - /* These write-once registers are normally cleared on reset. - * Restore BIOS values... which we HOPE were present before - * reset. - */ - if (!impl_save) { - impl_save = (1 << ahci_nr_ports(cap_save)) - 1; - dev_printk(KERN_WARNING, &pdev->dev, - "PORTS_IMPL is zero, forcing 0x%x\n", impl_save); - } - writel(cap_save, mmio + HOST_CAP); - writel(impl_save, mmio + HOST_PORTS_IMPL); - (void) readl(mmio + HOST_PORTS_IMPL); /* flush */ + /* some registers might be cleared on reset. restore initial values */ + ahci_restore_initial_config(mmio, hpriv); if (pdev->vendor == PCI_VENDOR_ID_INTEL) { u16 tmp16; @@ -1432,7 +1481,7 @@ static int ahci_pci_device_resume(struct pci_dev *pdev) return rc; if (pdev->dev.power.power_state.event == PM_EVENT_SUSPEND) { - rc = ahci_reset_controller(mmio, pdev); + rc = ahci_reset_controller(mmio, pdev, hpriv); if (rc) return rc; @@ -1543,12 +1592,10 @@ static int ahci_host_init(struct ata_probe_ent *probe_ent) unsigned int i, cap_n_ports, using_dac; int rc; - rc = ahci_reset_controller(mmio, pdev); + rc = ahci_reset_controller(mmio, pdev, hpriv); if (rc) return rc; - hpriv->cap = readl(mmio + HOST_CAP); - hpriv->port_map = readl(mmio + HOST_PORTS_IMPL); cap_n_ports = ahci_nr_ports(hpriv->cap); VPRINTK("cap 0x%x port_map 0x%x n_ports %d\n", @@ -1739,6 +1786,8 @@ static int ahci_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) probe_ent->private_data = hpriv; /* initialize adapter */ + ahci_save_initial_config(probe_ent); + rc = ahci_host_init(probe_ent); if (rc) return rc; -- 2.39.5