From c7b7b042068cd12b8b155722d24686f70b88ced1 Mon Sep 17 00:00:00 2001 From: David Brownell Date: Thu, 24 Jul 2008 17:47:56 -0700 Subject: [PATCH] enc28j60: don't specify (wrong) IRQ type Recent changes to the IRQ framework have made passing the wrong trigger type to request_irq() become a fatal error. In the case of the enc28j60 driver, it stopped working in my test harness. (Specifically: the signal detects "pin change" events, both edges, not just falling edges. Similarly, other boards might route it through an inverter. Trigger type are board-specific.) This fixes that problem by the usual fix of expecting board setup code to have set up the correct IRQ trigger type. The best known example of that being x86 setup. Signed-off-by: David Brownell Signed-off-by: Jeff Garzik --- drivers/net/enc28j60.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/drivers/net/enc28j60.c b/drivers/net/enc28j60.c index c05cb159c7..aa0bf6e1c6 100644 --- a/drivers/net/enc28j60.c +++ b/drivers/net/enc28j60.c @@ -1547,8 +1547,10 @@ static int __devinit enc28j60_probe(struct spi_device *spi) random_ether_addr(dev->dev_addr); enc28j60_set_hw_macaddr(dev); - ret = request_irq(spi->irq, enc28j60_irq, IRQF_TRIGGER_FALLING, - DRV_NAME, priv); + /* Board setup must set the relevant edge trigger type; + * level triggers won't currently work. + */ + ret = request_irq(spi->irq, enc28j60_irq, 0, DRV_NAME, priv); if (ret < 0) { if (netif_msg_probe(priv)) dev_err(&spi->dev, DRV_NAME ": request irq %d failed " -- 2.39.5