From 8035d3ea78c2a61a9738c7857742370e0aa74d5c Mon Sep 17 00:00:00 2001 From: Vivek Goyal Date: Wed, 2 May 2007 19:27:08 +0200 Subject: [PATCH] [PATCH] x86-64: Extend bzImage protocol for relocatable bzImage o Extend the bzImage protocol (same as i386) to allow bzImage loaders to load the protected mode kernel at non-1MB address. Now protected mode component is relocatable and can be loaded at non-1MB addresses. o As of today kdump uses it to run a second kernel from a reserved memory area. Signed-off-by: Vivek Goyal Signed-off-by: Vivek Goyal Signed-off-by: Andi Kleen --- arch/x86_64/boot/setup.S | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-) diff --git a/arch/x86_64/boot/setup.S b/arch/x86_64/boot/setup.S index 770940cc01..deb3573c7a 100644 --- a/arch/x86_64/boot/setup.S +++ b/arch/x86_64/boot/setup.S @@ -80,7 +80,7 @@ start: # This is the setup header, and it must start at %cs:2 (old 0x9020:2) .ascii "HdrS" # header signature - .word 0x0204 # header version number (>= 0x0105) + .word 0x0205 # header version number (>= 0x0105) # or else old loadlin-1.5 will fail) realmode_swtch: .word 0, 0 # default_switch, SETUPSEG start_sys_seg: .word SYSSEG @@ -155,7 +155,16 @@ cmd_line_ptr: .long 0 # (Header version 0x0202 or later) # low memory 0x10000 or higher. ramdisk_max: .long 0xffffffff - +kernel_alignment: .long 0x200000 # physical addr alignment required for + # protected mode relocatable kernel +#ifdef CONFIG_RELOCATABLE +relocatable_kernel: .byte 1 +#else +relocatable_kernel: .byte 0 +#endif +pad2: .byte 0 +pad3: .word 0 + trampoline: call start_of_setup .align 16 # The offset at this point is 0x240 -- 2.39.5