From 7a7d23dac29825a75e375800573d53e49d864a42 Mon Sep 17 00:00:00 2001 From: Grant Grundler Date: Sun, 17 Feb 2008 11:30:23 -0700 Subject: [PATCH] uli526x partially recognizing interface Patch fixes: http://bugzilla.kernel.org/show_bug.cgi?id=5839 Init sequence needs to poll phy until phy reset is complete. This is the same problem that I fixed in 2002 in tulip driver. Thanks to manty@manty.net for testing this patch. Thanks to Pozsar Balazs for posting/testing a similar patch before: http://lkml.org/lkml/2006/8/21/45 Signed-off-by: Grant Grundler Signed-off-by: Jeff Garzik --- drivers/net/tulip/uli526x.c | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-) diff --git a/drivers/net/tulip/uli526x.c b/drivers/net/tulip/uli526x.c index a7afeea156..a59c1f224a 100644 --- a/drivers/net/tulip/uli526x.c +++ b/drivers/net/tulip/uli526x.c @@ -482,9 +482,11 @@ static void uli526x_init(struct net_device *dev) struct uli526x_board_info *db = netdev_priv(dev); unsigned long ioaddr = db->ioaddr; u8 phy_tmp; + u8 timeout; u16 phy_value; u16 phy_reg_reset; + ULI526X_DBUG(0, "uli526x_init()", 0); /* Reset M526x MAC controller */ @@ -509,11 +511,19 @@ static void uli526x_init(struct net_device *dev) /* Parser SROM and media mode */ db->media_mode = uli526x_media_mode; - /* Phyxcer capability setting */ + /* phyxcer capability setting */ phy_reg_reset = phy_read(db->ioaddr, db->phy_addr, 0, db->chip_id); phy_reg_reset = (phy_reg_reset | 0x8000); phy_write(db->ioaddr, db->phy_addr, 0, phy_reg_reset, db->chip_id); + + /* See IEEE 802.3-2002.pdf (Section 2, Chapter "22.2.4 Management + * functions") or phy data sheet for details on phy reset + */ udelay(500); + timeout = 10; + while (timeout-- && + phy_read(db->ioaddr, db->phy_addr, 0, db->chip_id) & 0x8000) + udelay(100); /* Process Phyxcer Media Mode */ uli526x_set_phyxcer(db); -- 2.39.5