From 562faf469f35bf63c0b021550811280c81bdc52e Mon Sep 17 00:00:00 2001 From: James Harper Date: Thu, 5 May 2005 15:14:18 -0700 Subject: [PATCH] [PATCH] fix PROMISC/bridging in TLAN driver This has been a problem for me for ages. When using bridging, the driver is switched into promiscuous mode before the link init is complete. The init complete routine then resets the promisc bit on the card so the kernel still thinks the card is in promiscuous mode but the card isn't. doh. I think this bug only shows up in bridging when the bridge is started at boot time (or something else that sets promisc at the same time the card was started). If promisc is enabled later it works. Here's a trivial (and hopefully correct) patch that works for me. It just calls the promisc/multicast setup routine after init. Cc: Jeff Garzik Signed-off-by: Andrew Morton --- drivers/net/tlan.c | 1 + 1 file changed, 1 insertion(+) diff --git a/drivers/net/tlan.c b/drivers/net/tlan.c index f0851c4240..9680a308c6 100644 --- a/drivers/net/tlan.c +++ b/drivers/net/tlan.c @@ -2392,6 +2392,7 @@ TLan_FinishReset( struct net_device *dev ) TLan_SetTimer( dev, (10*HZ), TLAN_TIMER_FINISH_RESET ); return; } + TLan_SetMulticastList(dev); } /* TLan_FinishReset */ -- 2.39.5