From 09a54101e15f43607722dee55f33d1962653c6cb Mon Sep 17 00:00:00 2001 From: Linas Vepstas Date: Fri, 10 Aug 2007 09:28:11 +1000 Subject: [PATCH] [POWERPC] pseries: Remove dead EEH video code Remove dead code, and a misleading comment about EEH checking for video devices. The removed code is a left-over from the olden days where there was concern over how video devices worked in Linux. We are never going to go that way again, so kill this. Signed-off-by: Linas Vepstas ---- arch/powerpc/platforms/pseries/eeh.c | 17 ----------------- 1 file changed, 17 deletions(-) Signed-off-by: Paul Mackerras --- arch/powerpc/platforms/pseries/eeh.c | 17 ----------------- 1 file changed, 17 deletions(-) diff --git a/arch/powerpc/platforms/pseries/eeh.c b/arch/powerpc/platforms/pseries/eeh.c index 41b64b370f..b242c6c34f 100644 --- a/arch/powerpc/platforms/pseries/eeh.c +++ b/arch/powerpc/platforms/pseries/eeh.c @@ -969,23 +969,6 @@ static void *early_enable_eeh(struct device_node *dn, void *data) } pdn->class_code = *class_code; - /* - * Now decide if we are going to "Disable" EEH checking - * for this device. We still run with the EEH hardware active, - * but we won't be checking for ff's. This means a driver - * could return bad data (very bad!), an interrupt handler could - * hang waiting on status bits that won't change, etc. - * But there are a few cases like display devices that make sense. - */ - enable = 1; /* i.e. we will do checking */ -#if 0 - if ((*class_code >> 16) == PCI_BASE_CLASS_DISPLAY) - enable = 0; -#endif - - if (!enable) - pdn->eeh_mode |= EEH_MODE_NOCHECK; - /* Ok... see if this device supports EEH. Some do, some don't, * and the only way to find out is to check each and every one. */ regs = of_get_property(dn, "reg", NULL); -- 2.39.5