From 07612e5f224613020c0ba17ce28e8eac052ef8ce Mon Sep 17 00:00:00 2001 From: Sonic Zhang Date: Tue, 4 Dec 2007 23:45:21 -0800 Subject: [PATCH] spi: spi_bfin: resequence DMA start/stop Set correct baud for spi mmc and enable SPI only after DMA is started. Signed-off-by: Sonic Zhang Signed-off-by: Bryan Wu Signed-off-by: David Brownell Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- drivers/spi/spi_bfin5xx.c | 30 +++++++++++++++++++----------- 1 file changed, 19 insertions(+), 11 deletions(-) diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c index 4dc7e67493..a85bcb3065 100644 --- a/drivers/spi/spi_bfin5xx.c +++ b/drivers/spi/spi_bfin5xx.c @@ -231,13 +231,13 @@ static int restore_state(struct driver_data *drv_data) dev_dbg(&drv_data->pdev->dev, "restoring spi ctl state\n"); /* Load the registers */ - cs_deactive(drv_data, chip); write_BAUD(drv_data, chip->baud); chip->ctl_reg &= (~BIT_CTL_TIMOD); chip->ctl_reg |= (chip->width << 8); write_CTRL(drv_data, chip->ctl_reg); bfin_spi_enable(drv_data); + cs_active(drv_data, chip); if (ret) dev_dbg(&drv_data->pdev->dev, @@ -767,6 +767,7 @@ static void pump_transfers(unsigned long data) disable_dma(drv_data->dma_channel); clear_dma_irqstat(drv_data->dma_channel); + bfin_spi_disable(drv_data); /* config dma channel */ dev_dbg(&drv_data->pdev->dev, "doing dma transfer\n"); @@ -789,9 +790,6 @@ static void pump_transfers(unsigned long data) dev_dbg(&drv_data->pdev->dev, "doing autobuffer DMA out.\n"); - /* set SPI transfer mode */ - write_CTRL(drv_data, (cr | CFG_SPI_DMAWRITE)); - /* no irq in autobuffer mode */ dma_config = (DMAFLOW_AUTO | RESTART | dma_width | DI_EN); @@ -800,7 +798,13 @@ static void pump_transfers(unsigned long data) (unsigned long)drv_data->tx); enable_dma(drv_data->dma_channel); - /* just return here, there can only be one transfer in this mode */ + /* start SPI transfer */ + write_CTRL(drv_data, + (cr | CFG_SPI_DMAWRITE | BIT_CTL_ENABLE)); + + /* just return here, there can only be one transfer + * in this mode + */ message->status = 0; giveback(drv_data); return; @@ -811,9 +815,6 @@ static void pump_transfers(unsigned long data) /* set transfer mode, and enable SPI */ dev_dbg(&drv_data->pdev->dev, "doing DMA in.\n"); - /* set SPI transfer mode */ - write_CTRL(drv_data, (cr | CFG_SPI_DMAREAD)); - /* clear tx reg soformer data is not shifted out */ write_TDBR(drv_data, 0xFFFF); @@ -827,12 +828,13 @@ static void pump_transfers(unsigned long data) (unsigned long)drv_data->rx); enable_dma(drv_data->dma_channel); + /* start SPI transfer */ + write_CTRL(drv_data, + (cr | CFG_SPI_DMAREAD | BIT_CTL_ENABLE)); + } else if (drv_data->tx != NULL) { dev_dbg(&drv_data->pdev->dev, "doing DMA out.\n"); - /* set SPI transfer mode */ - write_CTRL(drv_data, (cr | CFG_SPI_DMAWRITE)); - /* start dma */ dma_enable_irq(drv_data->dma_channel); dma_config = (RESTART | dma_width | DI_EN); @@ -840,6 +842,10 @@ static void pump_transfers(unsigned long data) set_dma_start_addr(drv_data->dma_channel, (unsigned long)drv_data->tx); enable_dma(drv_data->dma_channel); + + /* start SPI transfer */ + write_CTRL(drv_data, + (cr | CFG_SPI_DMAWRITE | BIT_CTL_ENABLE)); } } else { /* IO mode write then read */ @@ -1142,6 +1148,8 @@ static int setup(struct spi_device *spi) peripheral_request(ssel[spi->master->bus_num] [chip->chip_select_num-1], DRV_NAME); + cs_deactive(drv_data, chip); + return 0; } -- 2.39.5