From 02eaa66629a29cd5712fe81a360c3ab5b1fc9531 Mon Sep 17 00:00:00 2001 From: Jeff Garzik Date: Sat, 12 Nov 2005 01:32:19 -0500 Subject: [PATCH] [libata ahci] set port ATAPI bit correctly Although according to the documentation this largely only affects desktop LED control, let's make sure we set the ATAPI bit when we have an ATAPI device attached to the port. --- drivers/scsi/ahci.c | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-) diff --git a/drivers/scsi/ahci.c b/drivers/scsi/ahci.c index 7b0640bc00..4e96ec5f2f 100644 --- a/drivers/scsi/ahci.c +++ b/drivers/scsi/ahci.c @@ -134,6 +134,7 @@ enum { PORT_IRQ_D2H_REG_FIS, /* PORT_CMD bits */ + PORT_CMD_ATAPI = (1 << 24), /* Device is ATAPI */ PORT_CMD_LIST_ON = (1 << 15), /* cmd list DMA engine running */ PORT_CMD_FIS_ON = (1 << 14), /* FIS DMA engine running */ PORT_CMD_FIS_RX = (1 << 4), /* Enable FIS receive DMA engine */ @@ -441,7 +442,7 @@ static void ahci_phy_reset(struct ata_port *ap) void __iomem *port_mmio = (void __iomem *) ap->ioaddr.cmd_addr; struct ata_taskfile tf; struct ata_device *dev = &ap->device[0]; - u32 tmp; + u32 new_tmp, tmp; __sata_phy_reset(ap); @@ -455,8 +456,21 @@ static void ahci_phy_reset(struct ata_port *ap) tf.nsect = (tmp) & 0xff; dev->class = ata_dev_classify(&tf); - if (!ata_dev_present(dev)) + if (!ata_dev_present(dev)) { ata_port_disable(ap); + return; + } + + /* Make sure port's ATAPI bit is set appropriately */ + new_tmp = tmp = readl(port_mmio + PORT_CMD); + if (dev->class == ATA_DEV_ATAPI) + new_tmp |= PORT_CMD_ATAPI; + else + new_tmp &= ~PORT_CMD_ATAPI; + if (new_tmp != tmp) { + writel(new_tmp, port_mmio + PORT_CMD); + readl(port_mmio + PORT_CMD); /* flush */ + } } static u8 ahci_check_status(struct ata_port *ap) -- 2.39.5