Jeff Kirsher [Fri, 13 Jan 2006 00:50:39 +0000 (16:50 -0800)]
[PATCH] e1000: Fix adapter structure and prepare for multique fix
Fix adapter structure to handle multiple queues and prepping the driver for full multiple queue support, some changes are ifdef'd our unless you define CONFIG_E1000_MQ.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by: John Ronciak <john.ronciak@intel.com> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
Jeff Kirsher [Fri, 13 Jan 2006 00:50:23 +0000 (16:50 -0800)]
[PATCH] e1000: Fix TSO
Fixed the TSO workaround for 82571/2 controllers.
Fixed TSO issue where a non-tso packet in a linear SKB which followed a TSO packet would get written back prematurely.
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by: John Ronciak <john.ronciak@intel.com> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
Arnd Bergmann [Thu, 12 Jan 2006 22:16:44 +0000 (17:16 -0500)]
[PATCH] spidernet: performance optimizations
Performance optimizations, changes in these areas:
- RX and TX checksum offload
- correct maximum MTU
- don't use TX interrupts anymore, use a timer instead
- remove some superfluous barriers
- improve RX RAM full handling
Arnd Bergmann [Thu, 12 Jan 2006 22:16:42 +0000 (17:16 -0500)]
[PATCH] spidernet: read firmware from the OF device tree
request_firmware() is sometimes problematic, especially
in initramfs, reading the firmware from Open Firmware
is much preferrable.
We still try to get the firmware from the file system
first, in order to support old SLOF releases and to allow
updates of the spidernet firmware without reflashing
the system.
Dale Farnsworth [Tue, 17 Jan 2006 00:00:24 +0000 (17:00 -0700)]
[PATCH] mv643xx_eth: Remove needless mask of extended intr register
All interrupts controlled by the extended mask register are also
masked by a bit in the main mask register, so there is no need to
directly manipulate the extended mask register.
Wolfram Joost [Mon, 16 Jan 2006 23:57:41 +0000 (16:57 -0700)]
[PATCH] mv643xx_eth: Request HW checksum generation only for IPv4
This patch removes the NETIF_F_HW_CSUM flag to be able to use other protocols
than IPv4. Hardware checksums for IPv4 should continue to work because
NETIF_F_IP_CSUM is still set. The sanity-check has been enhanced to check
the used protocol and to not access skb->iph for non-ipv4-packets.
Dale Farnsworth [Mon, 16 Jan 2006 23:56:30 +0000 (16:56 -0700)]
[PATCH] mv643xx_eth: Hold spinlocks only where needed
This driver has historically held a spin_lock during the entire open
and stop functions and while receiving multiple packets. This is
unecessarily long and holds locks during calls that may sleep.
This patch reduces the size of windows where locks are held.
The Marvell mv643xx ethernet hardware requires that DMA buffers be
aligned to 8-byte boundaries. This patch satisfies this requirement.
Buffers allocated by dev_alloc_skb() only have 4-byte alignment when
slab debugging is enabled.
Also, document that the 2-byte offset to align the IP packets on
receive is a hardware feature and is not tied to NET_IP_ALIGN.
Patch fixes a build problem with CONFIG_X86_VSMP. The vSMP bits probably
gathered some fuzz on its way to mainline, and safe_halt() which was outside
the #endif (CONFIG_X86_VSMP) somehow got inside the !CONFIG_X86_VSMP condition,
hence being undefined and breaking CONFIG_X86_VSMP builds. Patch takes
safe_halt() and halt() macros out of the #endif
Matt Tolentino [Tue, 17 Jan 2006 06:03:44 +0000 (07:03 +0100)]
[PATCH] x86_64: add __meminit for memory hotplug
Add __meminit to the __init lineup to ensure functions default
to __init when memory hotplug is not enabled. Replace __devinit
with __meminit on functions that were changed when the memory
hotplug code was introduced.
Matt Tolentino [Tue, 17 Jan 2006 06:03:41 +0000 (07:03 +0100)]
[PATCH] x86_64: add x86-64 support for memory hot-add
Add x86-64 specific memory hot-add functions, Kconfig options,
and runtime kernel page table update functions to make
hot-add usable on x86-64 machines. Also, fixup the nefarious
conditional locking and exports pointed out by Andi.
Tested on Intel and IBM x86-64 memory hot-add capable systems.
Andi Kleen [Tue, 17 Jan 2006 06:03:38 +0000 (07:03 +0100)]
[PATCH] x86_64: Flexmap for 32bit and randomized mappings for 64bit
Another try at this.
For 32bit follow the 32bit implementation from Ingo -
mappings are growing down from the end of stack now
and vary randomly by 1GB.
Randomized mappings for 64bit just vary the normal mmap break
by 1TB. I didn't bother implementing full flex mmap for 64bit
because it shouldn't be needed there.
... as they are no longer needed. Since there were hard-coded numbers in the
file, the patch also adds a mechanism to avoid these (otherwise potential
future changes would again and again require adjusting these numbers).
NeilBrown [Tue, 17 Jan 2006 06:14:57 +0000 (22:14 -0800)]
[PATCH] md: Clear clevel whenever level is set.
The 'level' of an md array can be set as either a number of a string. When
one is set, the other must be marked 'undefined'. This wasn't being done
in one place: where new arrays are created.
Result: if md1 is a raid1, it is stopped and a raid5 is created there, it
might still appear to be a raid1.
Signed-off-by: Neil Brown <neilb@suse.de> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Miklos Szeredi [Tue, 17 Jan 2006 06:14:52 +0000 (22:14 -0800)]
[PATCH] fuse: fix bitfield race
Fix race in setting bitfields of fuse_conn. Spotted by Andrew Morton.
The two fields ->connected and ->mounted were always changed with the
fuse_lock held. But other bitfields in the same structure were changed
without the lock. In theory this could lead to losing the assignment of
even the ones under lock. The chosen solution is to change these two
fields to be a full unsigned type. The other bitfields aren't "important"
enough to warrant the extra complexity of full locking or changing them to
bitops.
For all bitfields document why they are safe wrt. concurrent
assignments.
Also make the initialization of the 'num_waiting' atomic counter explicit.
Miklos Szeredi [Tue, 17 Jan 2006 06:14:46 +0000 (22:14 -0800)]
[PATCH] fuse: use asynchronous READ requests for readpages
This patch changes fuse_readpages() to send READ requests asynchronously.
This makes it possible for userspace filesystems to utilize the kernel
readahead logic instead of having to implement their own (resulting in double
caching).
Miklos Szeredi [Tue, 17 Jan 2006 06:14:41 +0000 (22:14 -0800)]
[PATCH] fuse: add connection aborting
Add ability to abort a filesystem connection.
With the introduction of asynchronous reads, the ability to interrupt any
request is not enough to dissolve deadlocks, since now waiting for the request
completion (page unlocked) is independent of the actual request, so in a
deadlock all threads will be uninterruptible.
The solution is to make it possible to abort all requests, even those
currently undergoing I/O to/from userspace. The natural interface for this is
'mount -f mountpoint', but that only works as long as the filesystem is
attached. So also add an 'abort' attribute to the sysfs view of the
connection.
Miklos Szeredi [Tue, 17 Jan 2006 06:14:38 +0000 (22:14 -0800)]
[PATCH] fuse: add number of waiting requests attribute
This patch adds the 'waiting' attribute which indicates how many filesystem
requests are currently waiting to be completed. A non-zero value without any
filesystem activity indicates a hung or deadlocked filesystem.
Miklos Szeredi [Tue, 17 Jan 2006 06:14:31 +0000 (22:14 -0800)]
[PATCH] fuse: introduce list for requests under I/O
Create a new list for requests in the process of being transfered to/from
userspace. This will be needed to be able to abort all requests even those
currently under I/O
Miklos Szeredi [Tue, 17 Jan 2006 06:14:26 +0000 (22:14 -0800)]
[PATCH] fuse: fix request_end()
This function used the request object after decrementing its reference count
and releasing the lock. This could in theory lead to all sorts of problems.
Miklos Szeredi [Tue, 17 Jan 2006 06:14:25 +0000 (22:14 -0800)]
[PATCH] fuse: fuse_copy_finish() order fix
fuse_copy_finish() must be called before request_end(), since the later might
sleep, and no sleeping is allowed between fuse_copy_one() and
fuse_copy_finish() because of kmap_atomic()/kunmap_atomic() used in them.
Bob Copeland [Tue, 17 Jan 2006 06:14:20 +0000 (22:14 -0800)]
[PATCH] partitions: Read Rio Karma partition table
The Rio Karma portable MP3 player has its own proprietary partition table.
The partition layout is similar to a DOS boot sector but it begins at a
different offset and uses a different magic number (0xAB56 instead of
0xAA55). Add support for it to enable mounting the device.
Signed-off-by: Bob Copeland <me@bobcopeland.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Paul Mundt [Tue, 17 Jan 2006 06:14:17 +0000 (22:14 -0800)]
[PATCH] sh: Simplistic clock framework
This adds a relatively simplistic clock framework for sh. The initial goal
behind this is to clean up the arch/sh/kernel/time.c mess and to get the CPU
subtype-specific frequency setting and calculation code moved somewhere more
sensible.
This only deals with the core clocks at the moment, though it's trivial for
other drivers to define their own clocks as desired.
Signed-off-by: Paul Mundt <lethal@linux-sh.org> Cc: john stultz <johnstul@us.ibm.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Paul Mundt [Tue, 17 Jan 2006 06:14:15 +0000 (22:14 -0800)]
[PATCH] sh: I/O routine cleanups and ioremap() overhaul
This introduces a few changes in the way that the I/O routines are defined on
SH, specifically so that things like the iomap API properly wrap through the
machvec for board-specific quirks.
In addition to this, the old p3_ioremap() work is converted to a more generic
__ioremap() that will map through the PMB if it's available, or fall back on
page tables for everything else.
An alpha-like IO_CONCAT is also added so we can start to clean up the
board-specific io.h mess, which will be handled in board update patches..
Signed-off-by: Paul Mundt <lethal@linux-sh.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Paul Mundt [Tue, 17 Jan 2006 06:14:14 +0000 (22:14 -0800)]
[PATCH] sh: IRQ handler updates
This moves the various IRQ controller drivers into a new subdirectory, and
also extends the INTC2 IRQ handler to also deal with SH7760 and SH7780
interrupts, rather than just ST-40.
The old CONFIG_SH_GENERIC has also been removed from the IRQ definitions, as
new ports are expected to be based off of CONFIG_SH_UNKNOWN. Since there are
plenty of incompatible machvecs, CONFIG_SH_GENERIC doesn't make sense anymore.
Signed-off-by: Paul Mundt <lethal@linux-sh.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Paul Mundt [Tue, 17 Jan 2006 06:14:09 +0000 (22:14 -0800)]
[PATCH] sh: DMA updates
This extends the current SH DMA API somewhat to support a proper virtual
channel abstraction, and also works to represent this through the driver model
by giving each DMAC its own platform device.
There's also a few other minor changes to support a few new CPU subtypes, and
make TEI generation for the SH DMAC configurable.
Signed-off-by: Paul Mundt <lethal@linux-sh.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Paul Mundt [Tue, 17 Jan 2006 06:14:08 +0000 (22:14 -0800)]
[PATCH] sh: consolidate hp620/hp680/hp690 targets into hp6xx
Most of the reasons for keeping these separate before was due to hp690
discontig, and since we have a workaround for that now (abusing some shadow
space so everything is magically contiguous), there's no reason to keep the
targets separate.
Signed-off-by: Paul Mundt <lethal@linux-sh.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
projects / linux-2.6 / log