Gerrit Renker [Mon, 27 Nov 2006 14:27:55 +0000 (12:27 -0200)]
[DCCP] ccid3: Remove redundant statements in ccid3_hc_tx_packet_sent
This patch removes a switch statement which is redundant since,
* nothing is done in states TFRC_SSTATE_NO_SENT/TFRC_SSTATE_NO_FBACK
* it is impossible that the function is called in the state TFRC_SSTATE_TERM, since
--the function is called, in dccp_write_xmit, after ccid3_hc_tx_send_packet
--if ccid3_hc_tx_send_packet is called in state TFRC_SSTATE_TERM, it returns
-EINVAL, which means that ccid3_hc_tx_packet_sent will not be called
(compare dccp_write_xmit)
--> therefore, this case is logically impossible
* the remaining state is TFRC_SSTATE_FBACK which conditionally updates t_ipi, t_nom,
and t_delta. This is a no-op, since
--t_ipi only changes when feedback is received
--however, when feedback arrives via ccid3_hc_tx_packet_recv, there is an identical
code block which performs the same set of operations
--performing the same set of operations again in ccid3_hc_tx_packet_sent therefore
does not change anything, since between the time of receiving the last feedback
(and therefore update of t_ipi, t_nom, and t_delta), the value of t_ipi has not
changed
--since t_ipi has not changed, the values of t_delta and t_nom also do not change,
they depend fully on t_ipi
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk> Acked-by: Ian McDonald <ian.mcdonald@jandi.co.nz> Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Gerrit Renker [Mon, 27 Nov 2006 14:26:57 +0000 (12:26 -0200)]
[DCCP] ccid3: Avoid congestion control on zero-sized data packets
This resolves an `XXX' in ccid3_hc_tx_send_packet().
The function is only called on Data and DataAck packets and returns a negative
result on zero-sized messages. This is a reasonable policy since CCID 3 is a
congestion-control module and congestion control on zero-sized Data(Ack)
packets is in a way pathological.
The patch uses a more suitable error code for this case, it returns the Posix.1
code `EBADMSG' ("Not a data message") instead of `ENOTCONN'.
As a result of ignoring zero-sized packets, a the condition for a warning
"First packet is data" in ccid3_hc_tx_packet_sent is always satisfied; this
message has been removed since it will always be printed.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk> Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz> Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Gerrit Renker [Mon, 27 Nov 2006 14:22:48 +0000 (12:22 -0200)]
[DCCP] ccid3: Simplify control flow in the calculation of t_ipi
This patch performs a simplifying (performance) optimisation:
In each call of the inline function ccid3_calc_new_t_ipi(), the state is
tested against TFRC_SSTATE_NO_FBACK. This is expensive when the function
is called very often. A simpler solution, implemented by this patch, is
to adapt the control flow.
Andrea Bittau [Sun, 26 Nov 2006 03:04:40 +0000 (01:04 -0200)]
[DCCP] ackvec: Split long ack vectors across multiple options
Ack vectors grow proportional to the window size. If an ack vector does not fit
into a single option, it must be spread across multiple options. This patch
will allow for windows to grow larger.
Committer note: Simplified the patch a bit, original algorithm kept.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk> Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Andrea Bittau [Fri, 24 Nov 2006 15:02:42 +0000 (13:02 -0200)]
[DCCP] ackvec: infrastructure for sending more than one ackvec per packet
Commiter note:
This was split from Andrea's original patch, in the process I changed the type
of the ackvec index fields to u16 instead of to int and haven't folded
dccp_ackvec_parse with dccp_ackvec_check_rcv_ackno.
Next patch will actually do the insertion of more than one ackvec per packet,
using, initially, up to a max of 2 ackvecs as per Andrea's original patch, then
I'll work on support for larger ackvecs, be it using a sysctl or using
setsockopt.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk> Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Ville Nuorvala [Sat, 25 Nov 2006 01:06:27 +0000 (17:06 -0800)]
[IPV6]: Do mandatory IPv6 tunnel endpoint checks in realtime
Doing the mandatory tunnel endpoint checks when the tunnel is set up
isn't enough as interfaces can go up or down and addresses can be
added or deleted after this. The checks need to be done realtime when
the tunnel is processing a packet.
Signed-off-by: Ville Nuorvala <vnuorval@tcs.hut.fi> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:22:08 +0000 (17:22 -0800)]
[SCTP]: sctp_make_asconf_update_ip() and sctp_find_unmatch_addr().
... switched to taking and returning pointers to net-endian
sctp_addr resp. Together, since the only user of sctp_find_unmatch_addr()
just passes its value to sctp_make_asconf_update_ip().
sctp_make_asconf_update_ip() is actually endian-agnostic.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:12:25 +0000 (17:12 -0800)]
[SCTP]: sctp_process_init() and sctp_source() switched to net-endian.
both are done in one go since almost always we have result of
the latter immediately passed to the former. Possibly non-obvious
note: sctp_process_param() is endian-agnostic
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:08:41 +0000 (17:08 -0800)]
[SCTP]: Switch sctp_assoc_is_match to net-endian.
Along with it, statics in input.c that end up calling it
(__sctp_lookup_association, sctp_lookup_association,
__sctp_rcv_init_lookup, __sctp_rcv_lookup). Callers
are adjusted.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:06:24 +0000 (17:06 -0800)]
[SCTP]: Annotate ->dst_saddr()
switched to taking a pointer to net-endian sctp_addr
and a net-endian port number. Instances and callers
adjusted; interestingly enough, the only calls are
direct calls of specific instances - the method is not
used at all.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:05:23 +0000 (17:05 -0800)]
[SCTP]: Switch ->cmp_addr() and sctp_cmp_addr_exact() to net-endian.
instances of ->cmp_addr() are fine with switching both arguments
to net-endian; callers other than in sctp_cmp_addr_exact() (both
as ->cmp_addr(...) and direct calls of instances) adjusted;
sctp_cmp_addr_exact() switched to net-endian itself and adjustment
is done in its callers
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:04:42 +0000 (17:04 -0800)]
[SCTP] embedded sctp_addr: net-endian mirrors
Add sctp_chunk->source, sctp_sockaddr_entry->a, sctp_transport->ipaddr
and sctp_transport->saddr, maintain them as net-endian mirrors of
their host-endian counterparts.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:04:10 +0000 (17:04 -0800)]
[SCTP]: Beginning of conversion to net-endian for embedded sctp_addr.
Part 1: rename sctp_chunk->source, sctp_sockaddr_entry->a,
sctp_transport->ipaddr and sctp_transport->saddr (to ..._h)
The next patch will reintroduce these fields and keep them as
net-endian mirrors of the original (renamed) ones. Split in
two patches to make sure that we hadn't forgotten any instanes.
Later in the series we'll eliminate uses of host-endian variants
(basically switching users to net-endian counterparts as we
progress through that mess). Then host-endian ones will die.
Other embedded host-endian sctp_addr will be easier to switch
directly, so we leave them alone for now.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
a) struct sockaddr_storage * passed to sctp_ulpevent_make_peer_addr_change()
actually points at union sctp_addr field in a structure. Then that sucker
gets copied to userland, with whatever junk we might have there.
b) it's actually having host-endian sin_port.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:02:22 +0000 (17:02 -0800)]
[SCTP] bug: sctp_assoc_lookup_laddr() is broken with ipv6.
It expects (and gets) laddr with net-endian sin_port. And then it calls
sctp_bind_addr_match(), which *does* care about port numbers in case of
ipv6 and expects them to be host-endian.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:02:01 +0000 (17:02 -0800)]
[SCTP]: Beginning of sin_port fixes.
That's going to be a long series. Introduced temporary helpers
doing copy-and-convert for sctp_addr; they are used to kill
flip-in-place in global data structures and will be used
to gradually push host-endian uses of sctp_addr out of existence.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
Al Viro [Tue, 21 Nov 2006 01:00:44 +0000 (17:00 -0800)]
[SCTP]: SCTP_CMD_INIT_FAILED annotations.
argument stored for SCTP_CMD_INIT_FAILED is always __be16
(protocol error). Introduced new field and accessor for
it (SCTP_PERR()); switched to their use (from SCTP_U32() and
.u32)
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: David S. Miller <davem@davemloft.net>
projects / linux-2.6 / log