From: Seokmann Ju Date: Thu, 17 Jan 2008 17:02:19 +0000 (-0800) Subject: [SCSI] qla2xxx: Issue correct MBC_INITIALIZE_FIRMWARE command. X-Git-Tag: v2.6.25-rc1~1230^2~19 X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=c48339decceec8e011498b0fc4c7c7d8b2ea06c1;p=linux-2.6 [SCSI] qla2xxx: Issue correct MBC_INITIALIZE_FIRMWARE command. There is a case where 54xx HBA loads MID firmware as it use 24xx firmware. In this case, the driver should issue MBC_MID_INITIALIZE FIRMWARE even though the HBA doesn't support NPIV. This patch make changes in the driver so that could behave accordingly. Signed-off-by: Seokmann Ju Signed-off-by: James Bottomley --- diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c index 7637fa7546..d0633ca894 100644 --- a/drivers/scsi/qla2xxx/qla_init.c +++ b/drivers/scsi/qla2xxx/qla_init.c @@ -1193,7 +1193,9 @@ qla2x00_init_rings(scsi_qla_host_t *ha) DEBUG(printk("scsi(%ld): Issue init firmware.\n", ha->host_no)); - mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports); + if (ha->flags.npiv_supported) + mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports); + mid_init_cb->options = __constant_cpu_to_le16(BIT_1); rval = qla2x00_init_firmware(ha, ha->init_cb_size); diff --git a/drivers/scsi/qla2xxx/qla_mbx.c b/drivers/scsi/qla2xxx/qla_mbx.c index 99d29fff83..0c10c0b0fb 100644 --- a/drivers/scsi/qla2xxx/qla_mbx.c +++ b/drivers/scsi/qla2xxx/qla_mbx.c @@ -980,7 +980,7 @@ qla2x00_init_firmware(scsi_qla_host_t *ha, uint16_t size) DEBUG11(printk("qla2x00_init_firmware(%ld): entered.\n", ha->host_no)); - if (ha->flags.npiv_supported) + if (ha->fw_attributes & BIT_2) mcp->mb[0] = MBC_MID_INITIALIZE_FIRMWARE; else mcp->mb[0] = MBC_INITIALIZE_FIRMWARE;