From: Bartlomiej Zolnierkiewicz Date: Wed, 16 Jul 2008 18:33:37 +0000 (+0200) Subject: ht6560b: convert to use ide_timing_find_mode() X-Git-Tag: v2.6.27-rc1~1049^2~63 X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=b32b76f72df17de891181b47e714f9f897bb62a1;p=linux-2.6 ht6560b: convert to use ide_timing_find_mode() There should be no functional changes caused by this patch. Acked-by: Sergei Shtylyov Signed-off-by: Bartlomiej Zolnierkiewicz --- diff --git a/drivers/ide/Kconfig b/drivers/ide/Kconfig index e9afafd55c..615e0bc018 100644 --- a/drivers/ide/Kconfig +++ b/drivers/ide/Kconfig @@ -1001,6 +1001,7 @@ config BLK_DEV_DTC2278 config BLK_DEV_HT6560B tristate "Holtek HT6560B support" + select IDE_TIMINGS help This driver is enabled at runtime using the "ht6560b.probe" kernel boot parameter. It enables support for the secondary IDE interface diff --git a/drivers/ide/legacy/ht6560b.c b/drivers/ide/legacy/ht6560b.c index dd6dfb32e8..bd2f579946 100644 --- a/drivers/ide/legacy/ht6560b.c +++ b/drivers/ide/legacy/ht6560b.c @@ -216,6 +216,7 @@ static u8 ht_pio2timings(ide_drive_t *drive, const u8 pio) if (pio) { unsigned int cycle_time; + struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio); cycle_time = ide_pio_cycle_time(drive, pio); @@ -224,10 +225,8 @@ static u8 ht_pio2timings(ide_drive_t *drive, const u8 pio) * actual cycle time for recovery and activity * according system bus speed. */ - active_time = ide_pio_timings[pio].active_time; - recovery_time = cycle_time - - active_time - - ide_pio_timings[pio].setup_time; + active_time = t->active; + recovery_time = cycle_time - active_time - t->setup; /* * Cycle times should be Vesa bus cycles */