From: David Brownell Date: Tue, 25 Sep 2007 14:17:48 +0000 (-0700) Subject: [AVR32] ngw100 i2c-gpio tweaks X-Git-Tag: v2.6.24-rc1~1461^2~2 X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=82c54f864fea26c4c44f27e2b4c4d9a811dde299;p=linux-2.6 [AVR32] ngw100 i2c-gpio tweaks Make the NGW100 bitbang i2c use open drain signaling. Also, speed it up, so it's closer to 100 kHz ... the code paths seem to be long enough that the udelay isn't dominating bit times. The peak bit rate I observed was around 125 kHz, but that's with large delays (usually before ACK/NAK) which hold the overall rate down to around 80 kHz (call it 100 usec/byte on average). Signed-off-by: David Brownell Signed-off-by: Haavard Skinnemoen --- diff --git a/arch/avr32/boards/atngw100/setup.c b/arch/avr32/boards/atngw100/setup.c index 6e180f4352..52987c81d6 100644 --- a/arch/avr32/boards/atngw100/setup.c +++ b/arch/avr32/boards/atngw100/setup.c @@ -125,8 +125,11 @@ static struct platform_device ngw_gpio_leds = { }; static struct i2c_gpio_platform_data i2c_gpio_data = { - .sda_pin = GPIO_PIN_PA(6), - .scl_pin = GPIO_PIN_PA(7), + .sda_pin = GPIO_PIN_PA(6), + .scl_pin = GPIO_PIN_PA(7), + .sda_is_open_drain = 1, + .scl_is_open_drain = 1, + .udelay = 2, /* close to 100 kHz */ }; static struct platform_device i2c_gpio_device = { @@ -162,8 +165,10 @@ static int __init atngw100_init(void) } platform_device_register(&ngw_gpio_leds); - at32_select_gpio(i2c_gpio_data.sda_pin, 0); - at32_select_gpio(i2c_gpio_data.scl_pin, 0); + at32_select_gpio(i2c_gpio_data.sda_pin, + AT32_GPIOF_MULTIDRV | AT32_GPIOF_OUTPUT | AT32_GPIOF_HIGH); + at32_select_gpio(i2c_gpio_data.scl_pin, + AT32_GPIOF_MULTIDRV | AT32_GPIOF_OUTPUT | AT32_GPIOF_HIGH); platform_device_register(&i2c_gpio_device); return 0;