From: Alan Cox Date: Wed, 22 Aug 2007 22:22:45 +0000 (+0100) Subject: libata: Spot bridge chips X-Git-Tag: v2.6.24-rc1~1391^2~83 X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=614fe29bd91f99cc1c1fbf3274fa918691044f47;p=linux-2.6 libata: Spot bridge chips If we have a PATA cable with a SATA drive on it then we've found a bridge and we can flip the cable type. This fixes some cable detect problems with SATA bridges on chipsets and misdetected cable types. In theory cable detection and mode limiting is needed if you put a SATA/PATA bridge on a 40 wire cable, but I see no way to deal with that other than to point out its not a good idea anyway. Signed-off-by: Alan Cox Signed-off-by: Jeff Garzik --- diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c index 43c329544c..b81265d1e4 100644 --- a/drivers/ata/libata-core.c +++ b/drivers/ata/libata-core.c @@ -2183,6 +2183,17 @@ int ata_bus_probe(struct ata_port *ap) if (ap->ops->cable_detect) ap->cbl = ap->ops->cable_detect(ap); + /* We may have SATA bridge glue hiding here irrespective of the + reported cable types and sensed types */ + ata_link_for_each_dev(dev, &ap->link) { + if (!ata_dev_enabled(dev)) + continue; + /* SATA drives indicate we have a bridge. We don't know which + end of the link the bridge is which is a problem */ + if (ata_id_is_sata(dev->id)) + ap->cbl = ATA_CBL_SATA; + } + /* After the identify sequence we can now set up the devices. We do this in the normal order so that the user doesn't get confused */