From: Alexey Dobriyan Date: Wed, 9 May 2007 14:52:35 +0000 (+0400) Subject: atl1: add netconsole support X-Git-Tag: v2.6.22-rc1~134 X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=497f050c42e46a4b1f6a9bcd8827fa5d97fe1feb;p=linux-2.6 atl1: add netconsole support Copied from b44 driver, but it works: netconsole: device eth0 not up yet, forcing it atl1: eth0 link is up 100 Mbps full duplex netconsole: network logging started Signed-off-by: Alexey Dobriyan Signed-off-by: Jeff Garzik --- diff --git a/drivers/net/atl1/atl1_main.c b/drivers/net/atl1/atl1_main.c index d28f88bbdd..78cf00ff3d 100644 --- a/drivers/net/atl1/atl1_main.c +++ b/drivers/net/atl1/atl1_main.c @@ -2038,6 +2038,15 @@ static int atl1_close(struct net_device *netdev) return 0; } +#ifdef CONFIG_NET_POLL_CONTROLLER +static void atl1_poll_controller(struct net_device *netdev) +{ + disable_irq(netdev->irq); + atl1_intr(netdev->irq, netdev); + enable_irq(netdev->irq); +} +#endif + /* * If TPD Buffer size equal to 0, PCIE DMAR_TO_INT * will assert. We do soft reset <0x1400=1> according @@ -2190,6 +2199,9 @@ static int __devinit atl1_probe(struct pci_dev *pdev, netdev->do_ioctl = &atl1_ioctl; netdev->tx_timeout = &atl1_tx_timeout; netdev->watchdog_timeo = 5 * HZ; +#ifdef CONFIG_NET_POLL_CONTROLLER + netdev->poll_controller = atl1_poll_controller; +#endif netdev->vlan_rx_register = atl1_vlan_rx_register; netdev->vlan_rx_add_vid = atl1_vlan_rx_add_vid; netdev->vlan_rx_kill_vid = atl1_vlan_rx_kill_vid;