From: shemminger@osdl.org Date: Wed, 26 Oct 2005 19:16:07 +0000 (-0700) Subject: [PATCH] sky2: remove unused definitions X-Git-Tag: v2.6.16-rc1~474^2~22^2~7^2~97^2~7 X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=488f84fd901cd3386f5723a3573ea2e1f55af537;p=linux-2.6 [PATCH] sky2: remove unused definitions The sky2 driver has a lot of register definitions, that were copied over from the skge driver, for areas that don't exist on the Yukon2. Signed-off-by: Stephen Hemminger Signed-off-by: Jeff Garzik --- diff --git a/drivers/net/sky2.h b/drivers/net/sky2.h index b1acdc606f..c15d46409b 100644 --- a/drivers/net/sky2.h +++ b/drivers/net/sky2.h @@ -85,21 +85,6 @@ enum csr_regs { B0_IMSK = 0x000c, B0_HWE_ISRC = 0x0010, B0_HWE_IMSK = 0x0014, - B0_SP_ISRC = 0x0018, - B0_XM1_IMSK = 0x0020, - B0_XM1_ISRC = 0x0028, - B0_XM1_PHY_ADDR = 0x0030, - B0_XM1_PHY_DATA = 0x0034, - B0_XM2_IMSK = 0x0040, - B0_XM2_ISRC = 0x0048, - B0_XM2_PHY_ADDR = 0x0050, - B0_XM2_PHY_DATA = 0x0054, - B0_R1_CSR = 0x0060, - B0_R2_CSR = 0x0064, - B0_XS1_CSR = 0x0068, - B0_XA1_CSR = 0x006c, - B0_XS2_CSR = 0x0070, - B0_XA2_CSR = 0x0074, /* Special ISR registers (Yukon-2 only) */ B0_Y2_SP_ISRC2 = 0x001c, @@ -116,36 +101,25 @@ enum csr_regs { B2_MAC_CFG = 0x011a, B2_CHIP_ID = 0x011b, B2_E_0 = 0x011c, - B2_E_1 = 0x011d, - B2_E_2 = 0x011e, + B2_Y2_CLK_GATE = 0x011d, B2_Y2_HW_RES = 0x011e, B2_E_3 = 0x011f, B2_Y2_CLK_CTRL = 0x0120, - B2_LD_CTRL = 0x0128, - B2_LD_TEST = 0x0129, + B2_TI_INI = 0x0130, B2_TI_VAL = 0x0134, B2_TI_CTRL = 0x0138, B2_TI_TEST = 0x0139, - B2_IRQM_INI = 0x0140, - B2_IRQM_VAL = 0x0144, - B2_IRQM_CTRL = 0x0148, - B2_IRQM_TEST = 0x0149, - B2_IRQM_MSK = 0x014c, - B2_IRQM_HWE_MSK = 0x0150, + B2_TST_CTRL1 = 0x0158, B2_TST_CTRL2 = 0x0159, B2_GP_IO = 0x015c, + B2_I2C_CTRL = 0x0160, B2_I2C_DATA = 0x0164, B2_I2C_IRQ = 0x0168, B2_I2C_SW = 0x016c, - B2_BSC_INI = 0x0170, - B2_BSC_VAL = 0x0174, - B2_BSC_CTRL = 0x0178, - B2_BSC_STAT = 0x0179, - B2_BSC_TST = 0x017a, B3_RAM_ADDR = 0x0180, B3_RAM_DATA_LO = 0x0184, @@ -220,8 +194,6 @@ enum { Y2_LED_STAT_ON = 1<<9, /* Status LED On (YUKON-2 only) */ Y2_LED_STAT_OFF = 1<<8, /* Status LED Off (YUKON-2 only) */ - CS_BUS_CLOCK = 1<<9, /* Bus Clock 0/1 = 33/66 MHz */ - CS_BUS_SLOT_SZ = 1<<8, /* Slot Size 0/1 = 32/64 bit slot */ CS_ST_SW_IRQ = 1<<7, /* Set IRQ SW Request */ CS_CL_SW_IRQ = 1<<6, /* Clear IRQ SW Request */ CS_STOP_DONE = 1<<5, /* Stop Master is finished */