From: Benjamin Herrenschmidt Date: Tue, 3 Oct 2006 04:47:58 +0000 (+1000) Subject: [POWERPC] Get default baud rate in udbg_scc X-Git-Tag: v2.6.19-rc1~35^2~10 X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=2ec6ef1034632c67896955d52bf8efb99195b742;p=linux-2.6 [POWERPC] Get default baud rate in udbg_scc On powermac, when open firmware is set to use the SCC for console, this causes the low level udbg early console to read back the speed and re-use it instead of hard coding 57600 bps. This doesn't (yet) pass the detected speed all the way to pmac_zilog though. Signed-off-by: Benjamin Herrenschmidt Signed-off-by: Paul Mackerras --- diff --git a/arch/powerpc/platforms/powermac/udbg_scc.c b/arch/powerpc/platforms/powermac/udbg_scc.c index ce1a235855..379db05b00 100644 --- a/arch/powerpc/platforms/powermac/udbg_scc.c +++ b/arch/powerpc/platforms/powermac/udbg_scc.c @@ -111,8 +111,6 @@ void udbg_scc_init(int force_scc) pmac_call_feature(PMAC_FTR_SCC_ENABLE, ch, PMAC_SCC_ASYNC | PMAC_SCC_FLAG_XMON, 1); - - /* Setup for 57600 8N1 */ if (ch == ch_a) addr += 0x20; sccc = ioremap(addr & PAGE_MASK, PAGE_SIZE) ; @@ -125,9 +123,21 @@ void udbg_scc_init(int force_scc) x = in_8(sccc); out_8(sccc, 0x09); /* reset A or B side */ out_8(sccc, 0xc0); + + /* If SCC was the OF output port, read the BRG value, else + * Setup for 57600 8N1 + */ + if (ch_def != NULL) { + out_8(sccc, 13); + scc_inittab[1] = in_8(sccc); + out_8(sccc, 12); + scc_inittab[3] = in_8(sccc); + } + for (i = 0; i < sizeof(scc_inittab); ++i) out_8(sccc, scc_inittab[i]); + udbg_putc = udbg_scc_putc; udbg_getc = udbg_scc_getc; udbg_getc_poll = udbg_scc_getc_poll;