#include <linux/mv643xx.h>
-#define BIT0 0x00000001
-#define BIT1 0x00000002
-#define BIT2 0x00000004
-#define BIT3 0x00000008
-#define BIT4 0x00000010
-#define BIT5 0x00000020
-#define BIT6 0x00000040
-#define BIT7 0x00000080
-#define BIT8 0x00000100
-#define BIT9 0x00000200
-#define BIT10 0x00000400
-#define BIT11 0x00000800
-#define BIT12 0x00001000
-#define BIT13 0x00002000
-#define BIT14 0x00004000
-#define BIT15 0x00008000
-#define BIT16 0x00010000
-#define BIT17 0x00020000
-#define BIT18 0x00040000
-#define BIT19 0x00080000
-#define BIT20 0x00100000
-#define BIT21 0x00200000
-#define BIT22 0x00400000
-#define BIT23 0x00800000
-#define BIT24 0x01000000
-#define BIT25 0x02000000
-#define BIT26 0x04000000
-#define BIT27 0x08000000
-#define BIT28 0x10000000
-#define BIT29 0x20000000
-#define BIT30 0x40000000
-#define BIT31 0x80000000
-
-/*
- * The first part is the high level driver of the gigE ethernet ports.
- */
-
/* Checksum offload for Tx works for most packets, but
* fails if previous packet sent did not use hw csum
*/
#define ETH_MIB_LATE_COLLISION 0x7c
/* Port serial status reg (PSR) */
-#define ETH_INTERFACE_GMII_MII 0
-#define ETH_INTERFACE_PCM BIT0
-#define ETH_LINK_IS_DOWN 0
-#define ETH_LINK_IS_UP BIT1
-#define ETH_PORT_AT_HALF_DUPLEX 0
-#define ETH_PORT_AT_FULL_DUPLEX BIT2
-#define ETH_RX_FLOW_CTRL_DISABLED 0
-#define ETH_RX_FLOW_CTRL_ENBALED BIT3
-#define ETH_GMII_SPEED_100_10 0
-#define ETH_GMII_SPEED_1000 BIT4
-#define ETH_MII_SPEED_10 0
-#define ETH_MII_SPEED_100 BIT5
-#define ETH_NO_TX 0
-#define ETH_TX_IN_PROGRESS BIT7
-#define ETH_BYPASS_NO_ACTIVE 0
-#define ETH_BYPASS_ACTIVE BIT8
-#define ETH_PORT_NOT_AT_PARTITION_STATE 0
-#define ETH_PORT_AT_PARTITION_STATE BIT9
-#define ETH_PORT_TX_FIFO_NOT_EMPTY 0
-#define ETH_PORT_TX_FIFO_EMPTY BIT10
-
-#define ETH_DEFAULT_RX_BPDU_QUEUE_3 (BIT23 | BIT22)
-#define ETH_DEFAULT_RX_BPDU_QUEUE_4 BIT24
-#define ETH_DEFAULT_RX_BPDU_QUEUE_5 (BIT24 | BIT22)
-#define ETH_DEFAULT_RX_BPDU_QUEUE_6 (BIT24 | BIT23)
-#define ETH_DEFAULT_RX_BPDU_QUEUE_7 (BIT24 | BIT23 | BIT22)
+#define ETH_INTERFACE_PCM 0x00000001
+#define ETH_LINK_IS_UP 0x00000002
+#define ETH_PORT_AT_FULL_DUPLEX 0x00000004
+#define ETH_RX_FLOW_CTRL_ENABLED 0x00000008
+#define ETH_GMII_SPEED_1000 0x00000010
+#define ETH_MII_SPEED_100 0x00000020
+#define ETH_TX_IN_PROGRESS 0x00000080
+#define ETH_BYPASS_ACTIVE 0x00000100
+#define ETH_PORT_AT_PARTITION_STATE 0x00000200
+#define ETH_PORT_TX_FIFO_EMPTY 0x00000400
/* SMI reg */
-#define ETH_SMI_BUSY BIT28 /* 0 - Write, 1 - Read */
-#define ETH_SMI_READ_VALID BIT27 /* 0 - Write, 1 - Read */
-#define ETH_SMI_OPCODE_WRITE 0 /* Completion of Read operation */
-#define ETH_SMI_OPCODE_READ BIT26 /* Operation is in progress */
+#define ETH_SMI_BUSY 0x10000000 /* 0 - Write, 1 - Read */
+#define ETH_SMI_READ_VALID 0x08000000 /* 0 - Write, 1 - Read */
+#define ETH_SMI_OPCODE_WRITE 0 /* Completion of Read */
+#define ETH_SMI_OPCODE_READ 0x04000000 /* Operation is in progress */
+
+/* Interrupt Cause Register Bit Definitions */
/* SDMA command status fields macros */
/* Tx & Rx descriptors status */
-#define ETH_ERROR_SUMMARY (BIT0)
+#define ETH_ERROR_SUMMARY 0x00000001
/* Tx & Rx descriptors command */
-#define ETH_BUFFER_OWNED_BY_DMA (BIT31)
+#define ETH_BUFFER_OWNED_BY_DMA 0x80000000
/* Tx descriptors status */
-#define ETH_LC_ERROR (0 )
-#define ETH_UR_ERROR (BIT1 )
-#define ETH_RL_ERROR (BIT2 )
-#define ETH_LLC_SNAP_FORMAT (BIT9 )
+#define ETH_LC_ERROR 0
+#define ETH_UR_ERROR 0x00000002
+#define ETH_RL_ERROR 0x00000004
+#define ETH_LLC_SNAP_FORMAT 0x00000200
/* Rx descriptors status */
-#define ETH_CRC_ERROR (0 )
-#define ETH_OVERRUN_ERROR (BIT1 )
-#define ETH_MAX_FRAME_LENGTH_ERROR (BIT2 )
-#define ETH_RESOURCE_ERROR ((BIT2 | BIT1))
-#define ETH_VLAN_TAGGED (BIT19)
-#define ETH_BPDU_FRAME (BIT20)
-#define ETH_TCP_FRAME_OVER_IP_V_4 (0 )
-#define ETH_UDP_FRAME_OVER_IP_V_4 (BIT21)
-#define ETH_OTHER_FRAME_TYPE (BIT22)
-#define ETH_LAYER_2_IS_ETH_V_2 (BIT23)
-#define ETH_FRAME_TYPE_IP_V_4 (BIT24)
-#define ETH_FRAME_HEADER_OK (BIT25)
-#define ETH_RX_LAST_DESC (BIT26)
-#define ETH_RX_FIRST_DESC (BIT27)
-#define ETH_UNKNOWN_DESTINATION_ADDR (BIT28)
-#define ETH_RX_ENABLE_INTERRUPT (BIT29)
-#define ETH_LAYER_4_CHECKSUM_OK (BIT30)
+#define ETH_OVERRUN_ERROR 0x00000002
+#define ETH_MAX_FRAME_LENGTH_ERROR 0x00000004
+#define ETH_RESOURCE_ERROR 0x00000006
+#define ETH_VLAN_TAGGED 0x00080000
+#define ETH_BPDU_FRAME 0x00100000
+#define ETH_UDP_FRAME_OVER_IP_V_4 0x00200000
+#define ETH_OTHER_FRAME_TYPE 0x00400000
+#define ETH_LAYER_2_IS_ETH_V_2 0x00800000
+#define ETH_FRAME_TYPE_IP_V_4 0x01000000
+#define ETH_FRAME_HEADER_OK 0x02000000
+#define ETH_RX_LAST_DESC 0x04000000
+#define ETH_RX_FIRST_DESC 0x08000000
+#define ETH_UNKNOWN_DESTINATION_ADDR 0x10000000
+#define ETH_RX_ENABLE_INTERRUPT 0x20000000
+#define ETH_LAYER_4_CHECKSUM_OK 0x40000000
/* Rx descriptors byte count */
-#define ETH_FRAME_FRAGMENTED (BIT2)
+#define ETH_FRAME_FRAGMENTED 0x00000004
/* Tx descriptors command */
-#define ETH_LAYER_4_CHECKSUM_FIRST_DESC (BIT10)
-#define ETH_FRAME_SET_TO_VLAN (BIT15)
-#define ETH_TCP_FRAME (0 )
-#define ETH_UDP_FRAME (BIT16)
-#define ETH_GEN_TCP_UDP_CHECKSUM (BIT17)
-#define ETH_GEN_IP_V_4_CHECKSUM (BIT18)
-#define ETH_ZERO_PADDING (BIT19)
-#define ETH_TX_LAST_DESC (BIT20)
-#define ETH_TX_FIRST_DESC (BIT21)
-#define ETH_GEN_CRC (BIT22)
-#define ETH_TX_ENABLE_INTERRUPT (BIT23)
-#define ETH_AUTO_MODE (BIT30)
+#define ETH_LAYER_4_CHECKSUM_FIRST_DESC 0x00000400
+#define ETH_FRAME_SET_TO_VLAN 0x00008000
+#define ETH_UDP_FRAME 0x00010000
+#define ETH_GEN_TCP_UDP_CHECKSUM 0x00020000
+#define ETH_GEN_IP_V_4_CHECKSUM 0x00040000
+#define ETH_ZERO_PADDING 0x00080000
+#define ETH_TX_LAST_DESC 0x00100000
+#define ETH_TX_FIRST_DESC 0x00200000
+#define ETH_GEN_CRC 0x00400000
+#define ETH_TX_ENABLE_INTERRUPT 0x00800000
+#define ETH_AUTO_MODE 0x40000000
#define ETH_TX_IHL_SHIFT 11
projects / linux-2.6 / commitdiff