]> err.no Git - linux-2.6/commitdiff
[Blackfin] arch: Add Support for ISP1362
authorMichael Hennerich <michael.hennerich@analog.com>
Sat, 2 Feb 2008 06:55:28 +0000 (14:55 +0800)
committerBryan Wu <bryan.wu@analog.com>
Sat, 2 Feb 2008 06:55:28 +0000 (14:55 +0800)
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
arch/blackfin/mach-bf561/boards/ezkit.c

index ed863ce9a2d8c13042160d0cba4d4bc7288f5291..d61e7ac056ee316e1ed1fda315c9b02a8ba10035 100644 (file)
@@ -92,6 +92,47 @@ void __exit bfin_isp1761_exit(void)
 arch_initcall(bfin_isp1761_init);
 #endif
 
+#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
+#include <linux/usb/isp1362.h>
+
+static struct resource isp1362_hcd_resources[] = {
+       {
+               .start = 0x2c060000,
+               .end = 0x2c060000,
+               .flags = IORESOURCE_MEM,
+       }, {
+               .start = 0x2c060004,
+               .end = 0x2c060004,
+               .flags = IORESOURCE_MEM,
+       }, {
+               .start = IRQ_PF8,
+               .end = IRQ_PF8,
+               .flags = IORESOURCE_IRQ,
+       },
+};
+
+static struct isp1362_platform_data isp1362_priv = {
+       .sel15Kres = 1,
+       .clknotstop = 0,
+       .oc_enable = 0,
+       .int_act_high = 0,
+       .int_edge_triggered = 0,
+       .remote_wakeup_connected = 0,
+       .no_power_switching = 1,
+       .power_switching_mode = 0,
+};
+
+static struct platform_device isp1362_hcd_device = {
+       .name = "isp1362-hcd",
+       .id = 0,
+       .dev = {
+               .platform_data = &isp1362_priv,
+       },
+       .num_resources = ARRAY_SIZE(isp1362_hcd_resources),
+       .resource = isp1362_hcd_resources,
+};
+#endif
+
 /*
  *  USB-LAN EzExtender board
  *  Driver needs to know address, irq and flag pin.
@@ -359,6 +400,11 @@ static struct platform_device *ezkit_devices[] __initdata = {
 #if defined(CONFIG_I2C_GPIO) || defined(CONFIG_I2C_GPIO_MODULE)
        &i2c_gpio_device,
 #endif
+
+#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
+       &isp1362_hcd_device,
+#endif
+
        &ezkit_flash_device,
 };