return retval;
}
-void usb_enable_root_hub_irq (struct usb_bus *bus)
-{
- struct usb_hcd *hcd;
-
- hcd = container_of (bus, struct usb_hcd, self);
- if (hcd->driver->hub_irq_enable && hcd->state != HC_STATE_HALT)
- hcd->driver->hub_irq_enable (hcd);
-}
-
/*-------------------------------------------------------------------------*/
int (*bus_suspend)(struct usb_hcd *);
int (*bus_resume)(struct usb_hcd *);
int (*start_port_reset)(struct usb_hcd *, unsigned port_num);
- void (*hub_irq_enable)(struct usb_hcd *);
- /* Needed only if port-change IRQs are level-triggered */
/* force handover of high-speed port to full-speed companion */
void (*relinquish_port)(struct usb_hcd *, int);
}
clear_bit(port1, hub->busy_bits);
- if (!hub->hdev->parent && !hub->busy_bits[0])
- usb_enable_root_hub_irq(hub->hdev->bus);
if (status == 0)
status = finish_port_resume(udev);
hub->activating = 0;
- /* If this is a root hub, tell the HCD it's okay to
- * re-enable port-change interrupts now. */
- if (!hdev->parent && !hub->busy_bits[0])
- usb_enable_root_hub_irq(hdev->bus);
-
loop_autopm:
/* Allow autosuspend if we're not going to run again */
if (list_empty(&hub->event_list))
break;
}
clear_bit(port1, parent_hub->busy_bits);
- if (!parent_hdev->parent && !parent_hub->busy_bits[0])
- usb_enable_root_hub_irq(parent_hdev->bus);
if (ret < 0)
goto re_enumerate;
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
.get_frame_number = ohci_get_frame,
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
/*-------------------------------------------------------------------------*/
-/* hcd->hub_irq_enable() */
-static void ohci_rhsc_enable (struct usb_hcd *hcd)
-{
- struct ohci_hcd *ohci = hcd_to_ohci (hcd);
-
- spin_lock_irq(&ohci->lock);
- if (!ohci->autostop)
- del_timer(&hcd->rh_timer); /* Prevent next poll */
- ohci_writel(ohci, OHCI_INTR_RHSC, &ohci->regs->intrenable);
- spin_unlock_irq(&ohci->lock);
-}
-
#define OHCI_SCHED_ENABLES \
(OHCI_CTRL_CLE|OHCI_CTRL_BLE|OHCI_CTRL_PLE|OHCI_CTRL_IE)
int any_connected)
{
int poll_rh = 1;
+ int rhsc;
+ rhsc = ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC;
switch (ohci->hc_control & OHCI_CTRL_HCFS) {
case OHCI_USB_OPER:
- /* keep on polling until we know a device is connected
- * and RHSC is enabled */
+ /* If no status changes are pending, enable status-change
+ * interrupts.
+ */
+ if (!rhsc && !changed) {
+ rhsc = OHCI_INTR_RHSC;
+ ohci_writel(ohci, rhsc, &ohci->regs->intrenable);
+ }
+
+ /* Keep on polling until we know a device is connected
+ * and RHSC is enabled, or until we autostop.
+ */
if (!ohci->autostop) {
if (any_connected ||
!device_may_wakeup(&ohci_to_hcd(ohci)
->self.root_hub->dev)) {
- if (ohci_readl(ohci, &ohci->regs->intrenable) &
- OHCI_INTR_RHSC)
+ if (rhsc)
poll_rh = 0;
} else {
ohci->autostop = 1;
ohci->autostop = 0;
ohci->next_statechange = jiffies +
STATECHANGE_DELAY;
- } else if (time_after_eq(jiffies,
+ } else if (rhsc && time_after_eq(jiffies,
ohci->next_statechange)
&& !ohci->ed_rm_list
&& !(ohci->hc_control &
OHCI_SCHED_ENABLES)) {
ohci_rh_suspend(ohci, 1);
+ poll_rh = 0;
}
}
break;
else
usb_hcd_resume_root_hub(ohci_to_hcd(ohci));
} else {
+ if (!rhsc && (ohci->autostop ||
+ ohci_to_hcd(ohci)->self.root_hub->
+ do_remote_wakeup))
+ ohci_writel(ohci, OHCI_INTR_RHSC,
+ &ohci->regs->intrenable);
+
/* everything is idle, no need for polling */
poll_rh = 0;
}
static int ohci_root_hub_state_changes(struct ohci_hcd *ohci, int changed,
int any_connected)
{
- int poll_rh = 1;
-
- /* keep on polling until RHSC is enabled */
+ /* If RHSC is enabled, don't poll */
if (ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC)
- poll_rh = 0;
- return poll_rh;
+ return 0;
+
+ /* If no status changes are pending, enable status-change interrupts */
+ if (!changed) {
+ ohci_writel(ohci, OHCI_INTR_RHSC, &ohci->regs->intrenable);
+ return 0;
+ }
+ return 1;
}
#endif /* CONFIG_PM */
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
.get_frame_number = ohci_get_frame,
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
.start_port_reset = ohci_start_port_reset,
#if defined(CONFIG_PM)
.bus_suspend = ohci_bus_suspend,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_s3c2410_hub_status_data,
.hub_control = ohci_s3c2410_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
- .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
return 0;
}
-static void u132_hub_irq_enable(struct usb_hcd *hcd)
-{
- struct u132 *u132 = hcd_to_u132(hcd);
- if (u132->going > 1) {
- dev_err(&u132->platform_dev->dev, "device has been removed %d\n"
- , u132->going);
- } else if (u132->going > 0)
- dev_err(&u132->platform_dev->dev, "device is being removed\n");
-}
-
#ifdef CONFIG_PM
static int u132_bus_suspend(struct usb_hcd *hcd)
.bus_suspend = u132_bus_suspend,
.bus_resume = u132_bus_resume,
.start_port_reset = u132_start_port_reset,
- .hub_irq_enable = u132_hub_irq_enable,
};
/*