Spelling fixes in arch/sparc64/.
Signed-off-by: Simon Arlott <simon@fire.lp0.eu>
Signed-off-by: David S. Miller <davem@davemloft.net>
#include <asm/timer.h>
#include <asm/cpudata.h>
-/* Used to synchronize acceses to NatSemi SUPER I/O chip configure
+/* Used to synchronize accesses to NatSemi SUPER I/O chip configure
* operations in asm/ns87303.h
*/
DEFINE_SPINLOCK(ns87303_lock);
/* Convert to num-entries. */
num_reg /= na + ns;
- /* Prevent overruning the op->resources[] array. */
+ /* Prevent overrunning the op->resources[] array. */
if (num_reg > PROMREG_MAX) {
printk(KERN_WARNING "%s: Too many regs (%d), "
"limiting to %d.\n",
op->num_irqs = 0;
}
- /* Prevent overruning the op->irqs[] array. */
+ /* Prevent overrunning the op->irqs[] array. */
if (op->num_irqs > PROMINTR_MAX) {
printk(KERN_WARNING "%s: Too many irqs (%d), "
"limiting to %d.\n",
/* Map a set of buffers described by SGLIST with NELEMS array
* elements in streaming mode for PCI DMA.
* When making changes here, inspect the assembly output. I was having
- * hard time to kepp this routine out of using stack slots for holding variables.
+ * hard time to keep this routine out of using stack slots for holding variables.
*/
static int pci_4u_map_sg(struct pci_dev *pdev, struct scatterlist *sglist, int nelems, int direction)
{
u64 msi_address;
- /* The format of this value is message type dependant.
+ /* The format of this value is message type dependent.
* For MSI bits 15:0 are the data from the MSI packet.
* For MSI-X bits 31:0 are the data from the MSI packet.
* For MSG, the message code and message routing code where:
* NOTE! Only a kernel-only process(ie the swapper or direct descendants
* who haven't done an "execve()") should use this: it will work within
* a system call from a "real" process, but the process memory space will
- * not be free'd until both the parent and the child have exited.
+ * not be freed until both the parent and the child have exited.
*/
pid_t kernel_thread(int (*fn)(void *), void * arg, unsigned long flags)
{
/* The interrupt map registers do not have an INO field
* like other chips do. They return zero in the INO
* field, and the interrupt controller number is controlled
- * in bits 6 thru 9. So in order for build_irq() to get
+ * in bits 6 to 9. So in order for build_irq() to get
* the INO right we pass it in as part of the fixup
* which will get added to the map register zero value
* read by build_irq().
if (initrd_start) {
size = initrd_end - initrd_start;
- /* Resert the initrd image area. */
+ /* Reserve the initrd image area. */
#ifdef CONFIG_DEBUG_BOOTMEM
prom_printf("reserve_bootmem(initrd): base[%llx] size[%lx]\n",
initrd_start, initrd_end);