]> err.no Git - linux-2.6/commitdiff
[PATCH] myri10ge: add page-based skb routines
authorBrice Goglin <brice@myri.com>
Mon, 11 Dec 2006 10:25:09 +0000 (11:25 +0100)
committerJeff Garzik <jeff@garzik.org>
Mon, 11 Dec 2006 14:54:06 +0000 (09:54 -0500)
Add physical page skb allocation routines and page based rx_done,
to be used by upcoming patches.

Signed-off-by: Brice Goglin <brice@myri.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
drivers/net/myri10ge/myri10ge.c

index 1e62f58ed2c2598aeb22df86ab8d6d05e8ff858a..05b4f93518f55587d8e48c52d4a96a773daecce7 100644 (file)
@@ -92,8 +92,14 @@ MODULE_LICENSE("Dual BSD/GPL");
 #define MYRI10GE_NO_CONFIRM_DATA htonl(0xffffffff)
 #define MYRI10GE_NO_RESPONSE_RESULT 0xffffffff
 
+#define MYRI10GE_ALLOC_ORDER 0
+#define MYRI10GE_ALLOC_SIZE ((1 << MYRI10GE_ALLOC_ORDER) * PAGE_SIZE)
+#define MYRI10GE_MAX_FRAGS_PER_FRAME (MYRI10GE_MAX_ETHER_MTU/MYRI10GE_ALLOC_SIZE + 1)
+
 struct myri10ge_rx_buffer_state {
        struct sk_buff *skb;
+       struct page *page;
+       int page_offset;
         DECLARE_PCI_UNMAP_ADDR(bus)
         DECLARE_PCI_UNMAP_LEN(len)
 };
@@ -116,9 +122,14 @@ struct myri10ge_rx_buf {
        u8 __iomem *wc_fifo;    /* w/c rx dma addr fifo address */
        struct mcp_kreq_ether_recv *shadow;     /* host shadow of recv ring */
        struct myri10ge_rx_buffer_state *info;
+       struct page *page;
+       dma_addr_t bus;
+       int page_offset;
        int cnt;
+       int fill_cnt;
        int alloc_fail;
        int mask;               /* number of rx slots -1 */
+       int watchdog_needed;
 };
 
 struct myri10ge_tx_buf {
@@ -150,6 +161,7 @@ struct myri10ge_priv {
        struct myri10ge_rx_buf rx_big;
        struct myri10ge_rx_done rx_done;
        int small_bytes;
+       int big_bytes;
        struct net_device *dev;
        struct net_device_stats stats;
        u8 __iomem *sram;
@@ -266,6 +278,10 @@ static int myri10ge_debug = -1;    /* defaults above */
 module_param(myri10ge_debug, int, 0);
 MODULE_PARM_DESC(myri10ge_debug, "Debug level (0=none,...,16=all)");
 
+static int myri10ge_fill_thresh = 256;
+module_param(myri10ge_fill_thresh, int, S_IRUGO | S_IWUSR);
+MODULE_PARM_DESC(myri10ge_fill_thresh, "Number of empty rx slots allowed\n");
+
 #define MYRI10GE_FW_OFFSET 1024*1024
 #define MYRI10GE_HIGHPART_TO_U32(X) \
 (sizeof (X) == 8) ? ((u32)((u64)(X) >> 32)) : (0)
@@ -958,6 +974,180 @@ static inline void myri10ge_vlan_ip_csum(struct sk_buff *skb, __wsum hw_csum)
        }
 }
 
+static inline void
+myri10ge_rx_skb_build(struct sk_buff *skb, u8 * va,
+                     struct skb_frag_struct *rx_frags, int len, int hlen)
+{
+       struct skb_frag_struct *skb_frags;
+
+       skb->len = skb->data_len = len;
+       skb->truesize = len + sizeof(struct sk_buff);
+       /* attach the page(s) */
+
+       skb_frags = skb_shinfo(skb)->frags;
+       while (len > 0) {
+               memcpy(skb_frags, rx_frags, sizeof(*skb_frags));
+               len -= rx_frags->size;
+               skb_frags++;
+               rx_frags++;
+               skb_shinfo(skb)->nr_frags++;
+       }
+
+       /* pskb_may_pull is not available in irq context, but
+        * skb_pull() (for ether_pad and eth_type_trans()) requires
+        * the beginning of the packet in skb_headlen(), move it
+        * manually */
+       memcpy(skb->data, va, hlen);
+       skb_shinfo(skb)->frags[0].page_offset += hlen;
+       skb_shinfo(skb)->frags[0].size -= hlen;
+       skb->data_len -= hlen;
+       skb->tail += hlen;
+       skb_pull(skb, MXGEFW_PAD);
+}
+
+static void
+myri10ge_alloc_rx_pages(struct myri10ge_priv *mgp, struct myri10ge_rx_buf *rx,
+                       int bytes, int watchdog)
+{
+       struct page *page;
+       int idx;
+
+       if (unlikely(rx->watchdog_needed && !watchdog))
+               return;
+
+       /* try to refill entire ring */
+       while (rx->fill_cnt != (rx->cnt + rx->mask + 1)) {
+               idx = rx->fill_cnt & rx->mask;
+
+               if ((bytes < MYRI10GE_ALLOC_SIZE / 2) &&
+                   (rx->page_offset + bytes <= MYRI10GE_ALLOC_SIZE)) {
+                       /* we can use part of previous page */
+                       get_page(rx->page);
+               } else {
+                       /* we need a new page */
+                       page =
+                           alloc_pages(GFP_ATOMIC | __GFP_COMP,
+                                       MYRI10GE_ALLOC_ORDER);
+                       if (unlikely(page == NULL)) {
+                               if (rx->fill_cnt - rx->cnt < 16)
+                                       rx->watchdog_needed = 1;
+                               return;
+                       }
+                       rx->page = page;
+                       rx->page_offset = 0;
+                       rx->bus = pci_map_page(mgp->pdev, page, 0,
+                                              MYRI10GE_ALLOC_SIZE,
+                                              PCI_DMA_FROMDEVICE);
+               }
+               rx->info[idx].page = rx->page;
+               rx->info[idx].page_offset = rx->page_offset;
+               /* note that this is the address of the start of the
+                * page */
+               pci_unmap_addr_set(&rx->info[idx], bus, rx->bus);
+               rx->shadow[idx].addr_low =
+                   htonl(MYRI10GE_LOWPART_TO_U32(rx->bus) + rx->page_offset);
+               rx->shadow[idx].addr_high =
+                   htonl(MYRI10GE_HIGHPART_TO_U32(rx->bus));
+
+               /* start next packet on a cacheline boundary */
+               rx->page_offset += SKB_DATA_ALIGN(bytes);
+               rx->fill_cnt++;
+
+               /* copy 8 descriptors to the firmware at a time */
+               if ((idx & 7) == 7) {
+                       if (rx->wc_fifo == NULL)
+                               myri10ge_submit_8rx(&rx->lanai[idx - 7],
+                                                   &rx->shadow[idx - 7]);
+                       else {
+                               mb();
+                               myri10ge_pio_copy(rx->wc_fifo,
+                                                 &rx->shadow[idx - 7], 64);
+                       }
+               }
+       }
+}
+
+static inline void
+myri10ge_unmap_rx_page(struct pci_dev *pdev,
+                      struct myri10ge_rx_buffer_state *info, int bytes)
+{
+       /* unmap the recvd page if we're the only or last user of it */
+       if (bytes >= MYRI10GE_ALLOC_SIZE / 2 ||
+           (info->page_offset + 2 * bytes) > MYRI10GE_ALLOC_SIZE) {
+               pci_unmap_page(pdev, (pci_unmap_addr(info, bus)
+                                     & ~(MYRI10GE_ALLOC_SIZE - 1)),
+                              MYRI10GE_ALLOC_SIZE, PCI_DMA_FROMDEVICE);
+       }
+}
+
+#define MYRI10GE_HLEN 64       /* The number of bytes to copy from a
+                                * page into an skb */
+
+static inline int
+myri10ge_page_rx_done(struct myri10ge_priv *mgp, struct myri10ge_rx_buf *rx,
+                     int bytes, int len, __wsum csum)
+{
+       struct sk_buff *skb;
+       struct skb_frag_struct rx_frags[MYRI10GE_MAX_FRAGS_PER_FRAME];
+       int i, idx, hlen, remainder;
+       struct pci_dev *pdev = mgp->pdev;
+       struct net_device *dev = mgp->dev;
+       u8 *va;
+
+       len += MXGEFW_PAD;
+       idx = rx->cnt & rx->mask;
+       va = page_address(rx->info[idx].page) + rx->info[idx].page_offset;
+       prefetch(va);
+       /* Fill skb_frag_struct(s) with data from our receive */
+       for (i = 0, remainder = len; remainder > 0; i++) {
+               myri10ge_unmap_rx_page(pdev, &rx->info[idx], bytes);
+               rx_frags[i].page = rx->info[idx].page;
+               rx_frags[i].page_offset = rx->info[idx].page_offset;
+               if (remainder < MYRI10GE_ALLOC_SIZE)
+                       rx_frags[i].size = remainder;
+               else
+                       rx_frags[i].size = MYRI10GE_ALLOC_SIZE;
+               rx->cnt++;
+               idx = rx->cnt & rx->mask;
+               remainder -= MYRI10GE_ALLOC_SIZE;
+       }
+
+       hlen = MYRI10GE_HLEN > len ? len : MYRI10GE_HLEN;
+
+       /* allocate an skb to attach the page(s) to. */
+
+       skb = netdev_alloc_skb(dev, MYRI10GE_HLEN + 16);
+       if (unlikely(skb == NULL)) {
+               mgp->stats.rx_dropped++;
+               do {
+                       i--;
+                       put_page(rx_frags[i].page);
+               } while (i != 0);
+               return 0;
+       }
+
+       /* Attach the pages to the skb, and trim off any padding */
+       myri10ge_rx_skb_build(skb, va, rx_frags, len, hlen);
+       if (skb_shinfo(skb)->frags[0].size <= 0) {
+               put_page(skb_shinfo(skb)->frags[0].page);
+               skb_shinfo(skb)->nr_frags = 0;
+       }
+       skb->protocol = eth_type_trans(skb, dev);
+       skb->dev = dev;
+
+       if (mgp->csum_flag) {
+               if ((skb->protocol == htons(ETH_P_IP)) ||
+                   (skb->protocol == htons(ETH_P_IPV6))) {
+                       skb->csum = csum;
+                       skb->ip_summed = CHECKSUM_COMPLETE;
+               } else
+                       myri10ge_vlan_ip_csum(skb, csum);
+       }
+       netif_receive_skb(skb);
+       dev->last_rx = jiffies;
+       return 1;
+}
+
 static inline unsigned long
 myri10ge_rx_done(struct myri10ge_priv *mgp, struct myri10ge_rx_buf *rx,
                 int bytes, int len, __wsum csum)