#include <linux/io.h>
#include <asm/arch/board.h>
+#include <asm/arch/cpu.h>
#ifdef CONFIG_MTD_NAND_ATMEL_ECC_HW
#define hard_ecc 1
uint8_t *ecc_pos;
int stat;
+ /*
+ * Errata: ALE is incorrectly wired up to the ECC controller
+ * on the AP7000, so it will include the address cycles in the
+ * ECC calculation.
+ *
+ * Workaround: Reset the parity registers before reading the
+ * actual data.
+ */
+ if (cpu_is_at32ap7000()) {
+ struct atmel_nand_host *host = chip->priv;
+ ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
+ }
+
/* read the page */
chip->read_buf(mtd, p, eccsize);
}
/*
- * Enable HW ECC : unsused
+ * Enable HW ECC : unused on most chips
*/
-static void atmel_nand_hwctl(struct mtd_info *mtd, int mode) { ; }
+static void atmel_nand_hwctl(struct mtd_info *mtd, int mode)
+{
+ if (cpu_is_at32ap7000()) {
+ struct nand_chip *nand_chip = mtd->priv;
+ struct atmel_nand_host *host = nand_chip->priv;
+ ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
+ }
+}
#ifdef CONFIG_MTD_PARTITIONS
static const char *part_probes[] = { "cmdlinepart", NULL };