* @tx_last_beacon: Determine whether the last IBSS beacon was sent by us.
* This is needed only for IBSS mode and the result of this function is
* used to determine whether to reply to Probe Requests.
+ *
+ * @conf_ht: Configures low level driver with 802.11n HT data. Must be atomic.
*/
struct ieee80211_ops {
int (*tx)(struct ieee80211_hw *hw, struct sk_buff *skb,
struct sk_buff *skb,
struct ieee80211_tx_control *control);
int (*tx_last_beacon)(struct ieee80211_hw *hw);
+ int (*conf_ht)(struct ieee80211_hw *hw, struct ieee80211_conf *conf);
};
/**
#include "debugfs.h"
#include "debugfs_netdev.h"
+#define SUPP_MCS_SET_LEN 16
+
/*
* For seeing transmitted packets on monitor interfaces
* we have a radiotap header too.
return ret;
}
+/**
+ * ieee80211_hw_config_ht should be used only after legacy configuration
+ * has been determined, as ht configuration depends upon the hardware's
+ * HT abilities for a _specific_ band.
+ */
+int ieee80211_hw_config_ht(struct ieee80211_local *local, int enable_ht,
+ struct ieee80211_ht_info *req_ht_cap,
+ struct ieee80211_ht_bss_info *req_bss_cap)
+{
+ struct ieee80211_conf *conf = &local->hw.conf;
+ struct ieee80211_hw_mode *mode = conf->mode;
+ int i;
+
+ /* HT is not supported */
+ if (!mode->ht_info.ht_supported) {
+ conf->flags &= ~IEEE80211_CONF_SUPPORT_HT_MODE;
+ return -EOPNOTSUPP;
+ }
+
+ /* disable HT */
+ if (!enable_ht) {
+ conf->flags &= ~IEEE80211_CONF_SUPPORT_HT_MODE;
+ } else {
+ conf->flags |= IEEE80211_CONF_SUPPORT_HT_MODE;
+ conf->ht_conf.cap = req_ht_cap->cap & mode->ht_info.cap;
+ conf->ht_conf.cap &= ~(IEEE80211_HT_CAP_MIMO_PS);
+ conf->ht_conf.cap |=
+ mode->ht_info.cap & IEEE80211_HT_CAP_MIMO_PS;
+ conf->ht_bss_conf.primary_channel =
+ req_bss_cap->primary_channel;
+ conf->ht_bss_conf.bss_cap = req_bss_cap->bss_cap;
+ conf->ht_bss_conf.bss_op_mode = req_bss_cap->bss_op_mode;
+ for (i = 0; i < SUPP_MCS_SET_LEN; i++)
+ conf->ht_conf.supp_mcs_set[i] =
+ mode->ht_info.supp_mcs_set[i] &
+ req_ht_cap->supp_mcs_set[i];
+
+ /* In STA mode, this gives us indication
+ * to the AP's mode of operation */
+ conf->ht_conf.ht_supported = 1;
+ conf->ht_conf.ampdu_factor = req_ht_cap->ampdu_factor;
+ conf->ht_conf.ampdu_density = req_ht_cap->ampdu_density;
+ }
+
+ local->ops->conf_ht(local_to_hw(local), &local->hw.conf);
+
+ return 0;
+}
+
void ieee80211_erp_info_change_notify(struct net_device *dev, u8 changes)
{
struct ieee80211_local *local = wdev_priv(dev->ieee80211_ptr);
void ieee80211_if_setup(struct net_device *dev);
struct ieee80211_rate *ieee80211_get_rate(struct ieee80211_local *local,
int phymode, int hwrate);
+int ieee80211_hw_config_ht(struct ieee80211_local *local, int enable_ht,
+ struct ieee80211_ht_info *req_ht_cap,
+ struct ieee80211_ht_bss_info *req_bss_cap);
/* ieee80211_ioctl.c */
extern const struct iw_handler_def ieee80211_iw_handler_def;
}
sta->supp_rates = rates;
+ if (elems.ht_cap_elem && elems.ht_info_elem && elems.wmm_param &&
+ local->ops->conf_ht) {
+ struct ieee80211_ht_bss_info bss_info;
+
+ ieee80211_ht_cap_ie_to_ht_info(
+ (struct ieee80211_ht_cap *)
+ elems.ht_cap_elem, &sta->ht_info);
+ ieee80211_ht_addt_info_ie_to_ht_bss_info(
+ (struct ieee80211_ht_addt_info *)
+ elems.ht_info_elem, &bss_info);
+ ieee80211_hw_config_ht(local, 1, &sta->ht_info, &bss_info);
+ }
+
rate_control_rate_init(sta, local);
if (elems.wmm_param && (ifsta->flags & IEEE80211_STA_WMM_ENABLED)) {
struct ieee80211_if_sta *ifsta;
size_t baselen;
struct ieee802_11_elems elems;
+ struct ieee80211_local *local = wdev_priv(dev->ieee80211_ptr);
+ struct ieee80211_conf *conf = &local->hw.conf;
ieee80211_rx_bss_info(dev, mgmt, len, rx_status, 1);
if (elems.erp_info && elems.erp_info_len >= 1)
ieee80211_handle_erp_ie(dev, elems.erp_info[0]);
+ if (elems.ht_cap_elem && elems.ht_info_elem &&
+ elems.wmm_param && local->ops->conf_ht &&
+ conf->flags & IEEE80211_CONF_SUPPORT_HT_MODE) {
+ struct ieee80211_ht_bss_info bss_info;
+
+ ieee80211_ht_addt_info_ie_to_ht_bss_info(
+ (struct ieee80211_ht_addt_info *)
+ elems.ht_info_elem, &bss_info);
+ /* check if AP changed bss inforamation */
+ if ((conf->ht_bss_conf.primary_channel !=
+ bss_info.primary_channel) ||
+ (conf->ht_bss_conf.bss_cap != bss_info.bss_cap) ||
+ (conf->ht_bss_conf.bss_op_mode != bss_info.bss_op_mode))
+ ieee80211_hw_config_ht(local, 1, &conf->ht_conf,
+ &bss_info);
+ }
+
if (elems.wmm_param && (ifsta->flags & IEEE80211_STA_WMM_ENABLED)) {
ieee80211_sta_wmm_params(dev, ifsta, elems.wmm_param,
elems.wmm_param_len);