* ata_dev_read_id - Read ID data from the specified device
* @dev: target device
* @p_class: pointer to class of the target device (may be changed)
- * @post_reset: is this read ID post-reset?
+ * @flags: ATA_READID_* flags
* @id: buffer to read IDENTIFY data into
*
* Read ID data from the specified device. ATA_CMD_ID_ATA is
* 0 on success, -errno otherwise.
*/
int ata_dev_read_id(struct ata_device *dev, unsigned int *p_class,
- int post_reset, u16 *id)
+ unsigned int flags, u16 *id)
{
struct ata_port *ap = dev->ap;
unsigned int class = *p_class;
goto err_out;
}
- if (post_reset && class == ATA_DEV_ATA) {
+ if ((flags & ATA_READID_POSTRESET) && class == ATA_DEV_ATA) {
/*
* The exact sequence expected by certain pre-ATA4 drives is:
* SRST RESET
/* current CHS translation info (id[53-58]) might be
* changed. reread the identify device info.
*/
- post_reset = 0;
+ flags &= ~ATA_READID_POSTRESET;
goto retry;
}
}
if (!ata_dev_enabled(dev))
continue;
- rc = ata_dev_read_id(dev, &dev->class, 1, dev->id);
+ rc = ata_dev_read_id(dev, &dev->class, ATA_READID_POSTRESET,
+ dev->id);
if (rc)
goto fail;
/**
* ata_dev_revalidate - Revalidate ATA device
* @dev: device to revalidate
- * @post_reset: is this revalidation after reset?
+ * @readid_flags: read ID flags
*
* Re-read IDENTIFY page and make sure @dev is still attached to
* the port.
* RETURNS:
* 0 on success, negative errno otherwise
*/
-int ata_dev_revalidate(struct ata_device *dev, int post_reset)
+int ata_dev_revalidate(struct ata_device *dev, unsigned int readid_flags)
{
unsigned int class = dev->class;
u16 *id = (void *)dev->ap->sector_buf;
}
/* read ID data */
- rc = ata_dev_read_id(dev, &class, post_reset, id);
+ rc = ata_dev_read_id(dev, &class, readid_flags, id);
if (rc)
goto fail;
DPRINTK("ENTER\n");
for (i = 0; i < ATA_MAX_DEVICES; i++) {
- unsigned int action;
+ unsigned int action, readid_flags = 0;
dev = &ap->device[i];
action = ata_eh_dev_action(dev);
+ if (ehc->i.flags & ATA_EHI_DID_RESET)
+ readid_flags |= ATA_READID_POSTRESET;
+
if (action & ATA_EH_REVALIDATE && ata_dev_ready(dev)) {
if (ata_port_offline(ap)) {
rc = -EIO;
}
ata_eh_about_to_do(ap, dev, ATA_EH_REVALIDATE);
- rc = ata_dev_revalidate(dev,
- ehc->i.flags & ATA_EHI_DID_RESET);
+ rc = ata_dev_revalidate(dev, readid_flags);
if (rc)
break;
ata_class_enabled(ehc->classes[dev->devno])) {
dev->class = ehc->classes[dev->devno];
- rc = ata_dev_read_id(dev, &dev->class, 1, dev->id);
+ rc = ata_dev_read_id(dev, &dev->class, readid_flags,
+ dev->id);
if (rc == 0) {
ehc->i.flags |= ATA_EHI_PRINTINFO;
rc = ata_dev_configure(dev);
};
/* libata-core.c */
+enum {
+ /* flags for ata_dev_read_id() */
+ ATA_READID_POSTRESET = (1 << 0), /* reading ID after reset */
+};
+
extern struct workqueue_struct *ata_aux_wq;
extern int atapi_enabled;
extern int atapi_dmadir;
int dma_dir, void *buf, unsigned int buflen);
extern unsigned int ata_do_simple_cmd(struct ata_device *dev, u8 cmd);
extern int ata_dev_read_id(struct ata_device *dev, unsigned int *p_class,
- int post_reset, u16 *id);
-extern int ata_dev_revalidate(struct ata_device *dev, int post_reset);
+ unsigned int flags, u16 *id);
+extern int ata_dev_revalidate(struct ata_device *dev, unsigned int flags);
extern int ata_dev_configure(struct ata_device *dev);
extern int sata_down_spd_limit(struct ata_port *ap);
extern int sata_set_spd_needed(struct ata_port *ap);