/*
- * include/asm-arm/arch-at91rm9200/at91rm9200_mci.h
+ * include/asm-arm/arch-at91rm9200/at91_mci.h
*
* Copyright (C) 2005 Ivan Kokshaysky
* Copyright (C) SAN People
*
* MultiMedia Card Interface (MCI) registers.
- * Based on AT91RM9200 datasheet revision E.
+ * Based on AT91RM9200 datasheet revision F.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* (at your option) any later version.
*/
-#ifndef AT91RM9200_MCI_H
-#define AT91RM9200_MCI_H
+#ifndef AT91_MCI_H
+#define AT91_MCI_H
#define AT91_MCI_CR 0x00 /* Control Register */
#define AT91_MCI_MCIEN (1 << 0) /* Multi-Media Interface Enable */
#define AT91_MCI_MR 0x04 /* Mode Register */
#define AT91_MCI_CLKDIV (0xff << 0) /* Clock Divider */
-#define AT91_MCI_PWSDIV (3 << 8) /* Power Saving Divider */
+#define AT91_MCI_PWSDIV (7 << 8) /* Power Saving Divider */
#define AT91_MCI_PDCPADV (1 << 14) /* PDC Padding Value */
#define AT91_MCI_PDCMODE (1 << 15) /* PDC-orientated Mode */
-#define AT91_MCI_BLKLEN (0xfff << 18) /* Data Block Length */
+#define AT91_MCI_BLKLEN (0xfff << 18) /* Data Block Length */
#define AT91_MCI_DTOR 0x08 /* Data Timeout Register */
#define AT91_MCI_DTOCYC (0xf << 0) /* Data Timeout Cycle Number */
#define AT91_MCI_DTOMUL_1M (7 << 4)
#define AT91_MCI_SDCR 0x0c /* SD Card Register */
-#define AT91_MCI_SDCSEL (0xf << 0) /* SD Card Selector */
-#define AT91_MCI_SDCBUS (1 << 7) /* 1-bit or 4-bit bus */
+#define AT91_MCI_SDCSEL (3 << 0) /* SD Card Selector */
+#define AT91_MCI_SDCBUS (1 << 7) /* 1-bit or 4-bit bus */
#define AT91_MCI_ARGR 0x10 /* Argument Register */
#define AT91_MCI_SR 0x40 /* Status Register */
#define AT91_MCI_CMDRDY (1 << 0) /* Command Ready */
-#define AT91_MCI_RXRDY (1 << 1) /* Receiver Ready */
+#define AT91_MCI_RXRDY (1 << 1) /* Receiver Ready */
#define AT91_MCI_TXRDY (1 << 2) /* Transmit Ready */
#define AT91_MCI_BLKE (1 << 3) /* Data Block Ended */
#define AT91_MCI_DTIP (1 << 4) /* Data Transfer in Progress */
#define AT91_MCI_NOTBUSY (1 << 5) /* Data Not Busy */
#define AT91_MCI_ENDRX (1 << 6) /* End of RX Buffer */
#define AT91_MCI_ENDTX (1 << 7) /* End fo TX Buffer */
+#define AT91_MCI_SDIOIRQA (1 << 8) /* SDIO Interrupt for Slot A */
+#define At91_MCI_SDIOIRQB (1 << 9) /* SDIO Interrupt for Slot B [AT91RM9200 only] */
#define AT91_MCI_RXBUFF (1 << 14) /* RX Buffer Full */
#define AT91_MCI_TXBUFE (1 << 15) /* TX Buffer Empty */
-#define AT91_MCI_RINDE (1 << 16) /* Response Index Error */
+#define AT91_MCI_RINDE (1 << 16) /* Response Index Error */
#define AT91_MCI_RDIRE (1 << 17) /* Response Direction Error */
-#define AT91_MCI_RCRCE (1 << 18) /* Response CRC Error */
+#define AT91_MCI_RCRCE (1 << 18) /* Response CRC Error */
#define AT91_MCI_RENDE (1 << 19) /* Response End Bit Error */
#define AT91_MCI_RTOE (1 << 20) /* Reponse Time-out Error */
#define AT91_MCI_DCRCE (1 << 21) /* Data CRC Error */
/*
- * include/asm-arm/arch-at91rm9200/at91rm9200_spi.h
+ * include/asm-arm/arch-at91rm9200/at91_spi.h
*
* Copyright (C) 2005 Ivan Kokshaysky
* Copyright (C) SAN People
* (at your option) any later version.
*/
-#ifndef AT91RM9200_SPI_H
-#define AT91RM9200_SPI_H
+#ifndef AT91_SPI_H
+#define AT91_SPI_H
#define AT91_SPI_CR 0x00 /* Control Register */
#define AT91_SPI_SPIEN (1 << 0) /* SPI Enable */
#define AT91_SPI_PS_FIXED (0 << 1)
#define AT91_SPI_PS_VARIABLE (1 << 1)
#define AT91_SPI_PCSDEC (1 << 2) /* Chip Select Decode */
-#define AT91_SPI_DIV32 (1 << 3) /* Clock Selection */
+#define AT91_SPI_DIV32 (1 << 3) /* Clock Selection [AT91RM9200 only] */
#define AT91_SPI_MODFDIS (1 << 4) /* Mode Fault Detection */
#define AT91_SPI_LLB (1 << 7) /* Local Loopback Enable */
#define AT91_SPI_PCS (0xf << 16) /* Peripheral Chip Select */
/*
- * include/asm-arm/arch-at91rm9200/at91rm9200_ssc.h
+ * include/asm-arm/arch-at91rm9200/at91_ssc.h
*
* Copyright (C) SAN People
*
* (at your option) any later version.
*/
-#ifndef AT91RM9200_SSC_H
-#define AT91RM9200_SSC_H
+#ifndef AT91_SSC_H
+#define AT91_SSC_H
#define AT91_SSC_CR 0x00 /* Control Register */
#define AT91_SSC_RXEN (1 << 0) /* Receive Enable */
#define AT91_SSC_CKI (1 << 5) /* Clock Inversion */
#define AT91_SSC_CKI_FALLING (0 << 5)
#define AT91_SSC_CK_RISING (1 << 5)
+#define AT91_SSC_CKG (1 << 6) /* Receive Clock Gating Selection [AT91SAM9261 only] */
+#define AT91_SSC_CKG_NONE (0 << 6)
+#define AT91_SSC_CKG_RFLOW (1 << 6)
+#define AT91_SSC_CKG_RFHIGH (2 << 6)
#define AT91_SSC_START (0xf << 8) /* Start Selection */
#define AT91_SSC_START_CONTINUOUS (0 << 8)
#define AT91_SSC_START_TX_RX (1 << 8)
#define AT91_SSC_START_RISING_RF (5 << 8)
#define AT91_SSC_START_LEVEL_RF (6 << 8)
#define AT91_SSC_START_EDGE_RF (7 << 8)
+#define AT91_SSC_STOP (1 << 12) /* Receive Stop Selection [AT91SAM9261 only] */
#define AT91_SSC_STTDLY (0xff << 16) /* Start Delay */
#define AT91_SSC_PERIOD (0xff << 24) /* Period Divider Selection */
#define AT91_SSC_RSHR 0x30 /* Receive Sync Holding Register */
#define AT91_SSC_TSHR 0x34 /* Transmit Sync Holding Register */
+#define AT91_SSC_RC0R 0x38 /* Receive Compare 0 Register [AT91SAM9261 only] */
+#define AT91_SSC_RC1R 0x3c /* Receive Compare 1 Register [AT91SAM9261 only] */
+
#define AT91_SSC_SR 0x40 /* Status Register */
#define AT91_SSC_TXRDY (1 << 0) /* Transmit Ready */
#define AT91_SSC_TXEMPTY (1 << 1) /* Transmit Empty */
#define AT91_SSC_OVRUN (1 << 5) /* Receive Overrun */
#define AT91_SSC_ENDRX (1 << 6) /* End of Reception */
#define AT91_SSC_RXBUFF (1 << 7) /* Receive Buffer Full */
+#define AT91_SSC_CP0 (1 << 8) /* Compare 0 [AT91SAM9261 only] */
+#define AT91_SSC_CP1 (1 << 9) /* Compare 1 [AT91SAM9261 only] */
#define AT91_SSC_TXSYN (1 << 10) /* Transmit Sync */
#define AT91_SSC_RXSYN (1 << 11) /* Receive Sync */
#define AT91_SSC_TXENA (1 << 16) /* Transmit Enable */
/*
- * include/asm-arm/arch-at91rm9200/at91rm9200_tc.h
+ * include/asm-arm/arch-at91rm9200/at91_tc.h
*
* Copyright (C) SAN People
*
* (at your option) any later version.
*/
-#ifndef AT91RM9200_TC_H
-#define AT91RM9200_TC_H
+#ifndef AT91_TC_H
+#define AT91_TC_H
#define AT91_TC_BCR 0xc0 /* TC Block Control Register */
#define AT91_TC_SYNC (1 << 0) /* Synchro Command */
/*
- * include/asm-arm/arch-at91rm9200/at91rm9200_twi.h
+ * include/asm-arm/arch-at91rm9200/at91_twi.h
*
* Copyright (C) 2005 Ivan Kokshaysky
* Copyright (C) SAN People
* (at your option) any later version.
*/
-#ifndef AT91RM9200_TWI_H
-#define AT91RM9200_TWI_H
+#ifndef AT91_TWI_H
+#define AT91_TWI_H
#define AT91_TWI_CR 0x00 /* Control Register */
#define AT91_TWI_START (1 << 0) /* Send a Start Condition */
#define AT91_TWI_TXCOMP (1 << 0) /* Transmission Complete */
#define AT91_TWI_RXRDY (1 << 1) /* Receive Holding Register Ready */
#define AT91_TWI_TXRDY (1 << 2) /* Transmit Holding Register Ready */
-#define AT91_TWI_OVRE (1 << 6) /* Overrun Error */
-#define AT91_TWI_UNRE (1 << 7) /* Underrun Error */
+#define AT91_TWI_OVRE (1 << 6) /* Overrun Error [AT91RM9200 only] */
+#define AT91_TWI_UNRE (1 << 7) /* Underrun Error [AT91RM9200 only] */
#define AT91_TWI_NACK (1 << 8) /* Not Acknowledged */
#define AT91_TWI_IER 0x24 /* Interrupt Enable Register */
+++ /dev/null
-/*
- * include/asm-arm/arch-at91rm9200/at91rm9200_pdc.h
- *
- * Copyright (C) 2005 Ivan Kokshaysky
- * Copyright (C) SAN People
- *
- * Peripheral Data Controller (PDC) registers.
- * Based on AT91RM9200 datasheet revision E.
- *
- * This program is free software; you can redistribute it and/or modify
- * it under the terms of the GNU General Public License as published by
- * the Free Software Foundation; either version 2 of the License, or
- * (at your option) any later version.
- */
-
-#ifndef AT91RM9200_PDC_H
-#define AT91RM9200_PDC_H
-
-#define AT91_PDC_RPR 0x100 /* Receive Pointer Register */
-#define AT91_PDC_RCR 0x104 /* Receive Counter Register */
-#define AT91_PDC_TPR 0x108 /* Transmit Pointer Register */
-#define AT91_PDC_TCR 0x10c /* Transmit Counter Register */
-#define AT91_PDC_RNPR 0x110 /* Receive Next Pointer Register */
-#define AT91_PDC_RNCR 0x114 /* Receive Next Counter Register */
-#define AT91_PDC_TNPR 0x118 /* Transmit Next Pointer Register */
-#define AT91_PDC_TNCR 0x11c /* Transmit Next Counter Register */
-
-#define AT91_PDC_PTCR 0x120 /* Transfer Control Register */
-#define AT91_PDC_RXTEN (1 << 0) /* Receiver Transfer Enable */
-#define AT91_PDC_RXTDIS (1 << 1) /* Receiver Transfer Disable */
-#define AT91_PDC_TXTEN (1 << 8) /* Transmitter Transfer Enable */
-#define AT91_PDC_TXTDIS (1 << 9) /* Transmitter Transfer Disable */
-
-#define AT91_PDC_PTSR 0x124 /* Transfer Status Register */
-
-#endif
projects / linux-2.6 / commitdiff