/**
* mv_err_intr - Handle error interrupts on the port
* @ap: ATA channel to manipulate
+ * @reset_allowed: bool: 0 == don't trigger from reset here
*
* In most cases, just clear the interrupt and move on. However,
* some cases require an eDMA reset, which is done right before
* LOCKING:
* Inherited from caller.
*/
-static void mv_err_intr(struct ata_port *ap)
+static void mv_err_intr(struct ata_port *ap, int reset_allowed)
{
void __iomem *port_mmio = mv_ap_base(ap);
u32 edma_err_cause, serr = 0;
writelfl(0, port_mmio + EDMA_ERR_IRQ_CAUSE_OFS);
/* check for fatal here and recover if needed */
- if (EDMA_ERR_FATAL & edma_err_cause) {
+ if (reset_allowed && (EDMA_ERR_FATAL & edma_err_cause))
mv_stop_and_reset(ap);
- }
}
/**
shift++; /* skip bit 8 in the HC Main IRQ reg */
}
if ((PORT0_ERR << shift) & relevant) {
- mv_err_intr(ap);
+ mv_err_intr(ap, 1);
err_mask |= AC_ERR_OTHER;
handled = 1;
}
ap->host_set->mmio_base, ap, qc, qc->scsicmd,
&qc->scsicmd->cmnd);
- mv_err_intr(ap);
+ mv_err_intr(ap, 0);
mv_stop_and_reset(ap);
- qc->err_mask |= AC_ERR_TIMEOUT;
- ata_eh_qc_complete(qc);
+ WARN_ON(!(qc->flags & ATA_QCFLAG_ACTIVE));
+ if (qc->flags & ATA_QCFLAG_ACTIVE) {
+ qc->err_mask |= AC_ERR_TIMEOUT;
+ ata_eh_qc_complete(qc);
+ }
}
/**