pxamci: fix byte aligned DMA transfers

The pxa27x DMA controller defaults to 64-bit alignment. This caused
the SCR reads to fail (and, depending on card type, error out) when
card->raw_scr was not aligned on a 8-byte boundary.

For performance reasons all scatter-gather addresses passed to
pxamci_request should be aligned on 8-byte boundaries, but if
this can't be guaranteed, byte aligned DMA transfers in the
have to be enabled in the controller to get correct behaviour.

Signed-off-by: Philipp Zabel <philipp.zabel@gmail.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

diff --git a/drivers/mmc/host/pxamci.c b/drivers/mmc/host/pxamci.c
index 65210fca37ede70f3c42199579b142e01a2a120c..d89475d36988228c09e60b54034c288bd81368e6 100644 (file)
--- a/drivers/mmc/host/pxamci.c
+++ b/drivers/mmc/host/pxamci.c
@@ -114,6 +114,7 @@ static void pxamci_setup_data(struct pxamci_host *host, struct mmc_data *data)
        unsigned int nob = data->blocks;
        unsigned long long clks;
        unsigned int timeout;
+       bool dalgn = 0;
        u32 dcmd;
        int i;
 
@@ -152,6 +153,9 @@ static void pxamci_setup_data(struct pxamci_host *host, struct mmc_data *data)
                host->sg_cpu[i].dcmd = dcmd | length;
                if (length & 31 && !(data->flags & MMC_DATA_READ))
                        host->sg_cpu[i].dcmd |= DCMD_ENDIRQEN;
+               /* Not aligned to 8-byte boundary? */
+               if (sg_dma_address(&data->sg[i]) & 0x7)
+                       dalgn = 1;
                if (data->flags & MMC_DATA_READ) {
                        host->sg_cpu[i].dsadr = host->res->start + MMC_RXFIFO;
                        host->sg_cpu[i].dtadr = sg_dma_address(&data->sg[i]);
@@ -165,6 +169,15 @@ static void pxamci_setup_data(struct pxamci_host *host, struct mmc_data *data)
        host->sg_cpu[host->dma_len - 1].ddadr = DDADR_STOP;
        wmb();
 
+       /*
+        * The PXA27x DMA controller encounters overhead when working with
+        * unaligned (to 8-byte boundaries) data, so switch on byte alignment
+        * mode only if we have unaligned data.
+        */
+       if (dalgn)
+               DALGN |= (1 << host->dma);
+       else
+               DALGN &= (1 << host->dma);
        DDADR(host->dma) = host->sg_dma;
        DCSR(host->dma) = DCSR_RUN;
 }