#define R300_RE_FOG_START 0x4298
/* Not sure why there are duplicate of factor and constant values.
- * My best guess so far is that there are seperate zbiases for test and write.
+ * My best guess so far is that there are separate zbiases for test and write.
* Ordering might be wrong.
* Some of the tests indicate that fgl has a fallback implementation of zbias
* via pixel shaders.
}
/*
- * This function is used internally by ring buffer mangement code.
+ * This function is used internally by ring buffer management code.
*
* Returns virtual pointer to ring buffer.
*/
*
* NOTES:
* - Locking is required for safe execution of EFI calls with regards
- * to interrrupts and SMP.
+ * to interrupts and SMP.
*
* TODO (December 1999):
* - provide the API to set/get the WakeUp Alarm (different from the
res |= cflag & ((CBAUD ^ CBAUDEX) | PARODD | PARENB | CSTOPB | CSIZE);
/*
* This gets a little confusing. The Digi cards have their own
- * representation of c_cflags controling baud rate. For the most part
+ * representation of c_cflags controlling baud rate. For the most part
* this is identical to the Linux implementation. However; Digi
* supports one rate (76800) that Linux doesn't. This means that the
* c_cflag entry that would normally mean 76800 for Digi actually means
{
/*
* This call is made by the apps to complete the
- * initilization of the board(s). This routine is
+ * initialization of the board(s). This routine is
* responsible for setting the card to its initial
* state and setting the drivers control fields to the
* sutianle settings for the card in question.
* The hangcheck-timer driver uses the TSC to catch delays that
* jiffies does not notice. A timer is set. When the timer fires, it
* checks whether it was delayed and if that delay exceeds a given
- * margin of error. The hangcheck_tick module paramter takes the timer
+ * margin of error. The hangcheck_tick module parameter takes the timer
* duration in seconds. The hangcheck_margin parameter defines the
* margin of error, in seconds. The defaults are 60 seconds for the
* timer and 180 seconds for the margin of error. IOW, a timer is set
if (!hvcsd)
return -ENODEV;
- /* By this time the vty-server won't be getting any more interrups */
+ /* By this time the vty-server won't be getting any more interrupts */
spin_lock_irqsave(&hvcsd->lock, flags);
if (!in_interrupt()) {
schedule_timeout_interruptible(1); // short nap
} else {
- // we cannot sched/sleep in interrrupt silly
+ // we cannot sched/sleep in interrupt silly
return 0;
}
if (signal_pending(current)) {
// Just polled boards, IRQ = 0 will hit all non-interrupt boards.
// It will NOT poll boards handled by hard interrupts.
- // The issue of queued BH interrups is handled in ip2_interrupt().
+ // The issue of queued BH interrupts is handled in ip2_interrupt().
ip2_polled_interrupt();
PollTimer.expires = POLL_TIMEOUT;
/* mgsl_isr_misc()
*
- * Service a miscellaneos interrupt source.
+ * Service a miscellaneous interrupt source.
*
* Arguments: info pointer to device extension (instance data)
* Return Value: None
if (tosh_probe())
return -ENODEV;
- printk(KERN_INFO "Toshiba System Managment Mode driver v" TOSH_VERSION "\n");
+ printk(KERN_INFO "Toshiba System Management Mode driver v" TOSH_VERSION "\n");
/* set the port to use for Fn status if not specified as a parameter */
if (tosh_fn==0x00)