* must always write descriptors to initialize the device, then
* the device becomes UNCONNECTED until enumeration.
*/
- STATE_OPENED,
+ STATE_DEV_OPENED,
/* From then on, ep0 fd is in either of two basic modes:
* - (UN)CONNECTED: read usb_gadgetfs_event(s) from it
* - SETUP: read/write will transfer control data and succeed;
* or if "wrong direction", performs protocol stall
*/
- STATE_UNCONNECTED,
- STATE_CONNECTED,
- STATE_SETUP,
+ STATE_DEV_UNCONNECTED,
+ STATE_DEV_CONNECTED,
+ STATE_DEV_SETUP,
/* UNBOUND means the driver closed ep0, so the device won't be
* accessible again (DEV_DISABLED) until all fds are closed.
struct dev_data {
spinlock_t lock;
atomic_t count;
- enum ep0_state state;
+ enum ep0_state state; /* P: lock */
struct usb_gadgetfs_event event [N_EVENT];
unsigned ev_next;
struct fasync_struct *fasync;
free = 0;
dev->setup_out_ready = 1;
ep0_readable (dev);
- } else if (dev->state == STATE_SETUP)
- dev->state = STATE_CONNECTED;
+ } else {
+ unsigned long flags;
+
+ spin_lock_irqsave(&dev->lock, flags);
+ if (dev->state == STATE_DEV_SETUP)
+ dev->state = STATE_DEV_CONNECTED;
+ spin_unlock_irqrestore(&dev->lock, flags);
+ }
/* clean up as appropriate */
if (free && req->buf != &dev->rbuf)
}
/* control DATA stage */
- if ((state = dev->state) == STATE_SETUP) {
+ if ((state = dev->state) == STATE_DEV_SETUP) {
if (dev->setup_in) { /* stall IN */
VDEBUG(dev, "ep0in stall\n");
(void) usb_ep_set_halt (dev->gadget->ep0);
retval = -EL2HLT;
- dev->state = STATE_CONNECTED;
+ dev->state = STATE_DEV_CONNECTED;
} else if (len == 0) { /* ack SET_CONFIGURATION etc */
struct usb_ep *ep = dev->gadget->ep0;
if ((retval = setup_req (ep, req, 0)) == 0)
retval = usb_ep_queue (ep, req, GFP_ATOMIC);
- dev->state = STATE_CONNECTED;
+ dev->state = STATE_DEV_CONNECTED;
/* assume that was SET_CONFIGURATION */
if (dev->current_config) {
len = min (len, tmp * sizeof (struct usb_gadgetfs_event));
n = len / sizeof (struct usb_gadgetfs_event);
- /* ep0 can't deliver events when STATE_SETUP */
+ /* ep0 can't deliver events when STATE_DEV_SETUP */
for (i = 0; i < n; i++) {
if (dev->event [i].type == GADGETFS_SETUP) {
len = i + 1;
sizeof (struct usb_gadgetfs_event)
* (tmp - len));
if (n == 0)
- dev->state = STATE_SETUP;
+ dev->state = STATE_DEV_SETUP;
spin_unlock_irq (&dev->lock);
}
return retval;
DBG (dev, "fail %s, state %d\n", __FUNCTION__, state);
retval = -ESRCH;
break;
- case STATE_UNCONNECTED:
- case STATE_CONNECTED:
+ case STATE_DEV_UNCONNECTED:
+ case STATE_DEV_CONNECTED:
spin_unlock_irq (&dev->lock);
DBG (dev, "%s wait\n", __FUNCTION__);
switch (type) {
/* these events purge the queue */
case GADGETFS_DISCONNECT:
- if (dev->state == STATE_SETUP)
+ if (dev->state == STATE_DEV_SETUP)
dev->setup_abort = 1;
// FALL THROUGH
case GADGETFS_CONNECT:
retval = -EIDRM;
/* data and/or status stage for control request */
- } else if (dev->state == STATE_SETUP) {
+ } else if (dev->state == STATE_DEV_SETUP) {
/* IN DATA+STATUS caller makes len <= wLength */
if (dev->setup_in) {
VDEBUG(dev, "ep0out stall\n");
(void) usb_ep_set_halt (dev->gadget->ep0);
retval = -EL2HLT;
- dev->state = STATE_CONNECTED;
+ dev->state = STATE_DEV_CONNECTED;
} else {
DBG(dev, "bogus ep0out stall!\n");
}
put_dev (dev);
/* other endpoints were all decoupled from this device */
+ spin_lock_irq(&dev->lock);
dev->state = STATE_DEV_DISABLED;
+ spin_unlock_irq(&dev->lock);
return 0;
}
goto out;
}
- if (dev->state == STATE_SETUP) {
+ if (dev->state == STATE_DEV_SETUP) {
if (dev->setup_in || dev->setup_can_stall)
mask = POLLOUT;
} else {
spin_lock (&dev->lock);
dev->setup_abort = 0;
- if (dev->state == STATE_UNCONNECTED) {
+ if (dev->state == STATE_DEV_UNCONNECTED) {
- dev->state = STATE_CONNECTED;
+ dev->state = STATE_DEV_CONNECTED;
dev->dev->bMaxPacketSize0 = gadget->ep0->maxpacket;
#ifdef CONFIG_USB_GADGET_DUALSPEED
* then ep0_{read,write} will report the wrong status. controller
* driver will have aborted pending i/o.
*/
- } else if (dev->state == STATE_SETUP)
+ } else if (dev->state == STATE_DEV_SETUP)
dev->setup_abort = 1;
req->buf = dev->rbuf;
}
/* proceed with data transfer and status phases? */
- if (value >= 0 && dev->state != STATE_SETUP) {
+ if (value >= 0 && dev->state != STATE_DEV_SETUP) {
req->length = value;
req->zero = value < w_length;
value = usb_ep_queue (gadget->ep0, req, GFP_ATOMIC);
goto enomem;
INFO (dev, "bound to %s driver\n", gadget->name);
- dev->state = STATE_UNCONNECTED;
+ spin_lock_irq(&dev->lock);
+ dev->state = STATE_DEV_UNCONNECTED;
+ spin_unlock_irq(&dev->lock);
get_dev (dev);
return 0;
struct dev_data *dev = get_gadget_data (gadget);
spin_lock (&dev->lock);
- if (dev->state == STATE_UNCONNECTED) {
- DBG (dev, "already unconnected\n");
+ if (dev->state == STATE_DEV_UNCONNECTED)
goto exit;
- }
- dev->state = STATE_UNCONNECTED;
+ dev->state = STATE_DEV_UNCONNECTED;
INFO (dev, "disconnected\n");
next_event (dev, GADGETFS_DISCONNECT);
INFO (dev, "suspended from state %d\n", dev->state);
spin_lock (&dev->lock);
switch (dev->state) {
- case STATE_SETUP: // VERY odd... host died??
- case STATE_CONNECTED:
- case STATE_UNCONNECTED:
+ case STATE_DEV_SETUP: // VERY odd... host died??
+ case STATE_DEV_CONNECTED:
+ case STATE_DEV_UNCONNECTED:
next_event (dev, GADGETFS_SUSPEND);
ep0_readable (dev);
/* FALLTHROUGH */
u32 tag;
char *kbuf;
- if (dev->state != STATE_OPENED)
- return -EEXIST;
-
if (len < (USB_DT_CONFIG_SIZE + USB_DT_DEVICE_SIZE + 4))
return -EINVAL;
struct dev_data *dev = inode->i_private;
int value = -EBUSY;
+ spin_lock_irq(&dev->lock);
if (dev->state == STATE_DEV_DISABLED) {
dev->ev_next = 0;
- dev->state = STATE_OPENED;
+ dev->state = STATE_DEV_OPENED;
fd->private_data = dev;
get_dev (dev);
value = 0;
}
+ spin_unlock_irq(&dev->lock);
return value;
}