.physical = IXP4XX_PCI_CFG_BASE_PHYS,
.length = IXP4XX_PCI_CFG_REGION_SIZE,
.type = MT_DEVICE
+ },
+#ifdef CONFIG_DEBUG_LL
+ { /* Debug UART mapping */
+ .virtual = IXP4XX_DEBUG_UART_BASE_VIRT,
+ .physical = IXP4XX_DEBUG_UART_BASE_PHYS,
+ .length = IXP4XX_DEBUG_UART_REGION_SIZE,
+ .type = MT_DEVICE
}
+#endif
};
void __init ixp4xx_map_io(void)
mrc p15, 0, \rx, c1, c0
tst \rx, #1 @ MMU enabled?
moveq \rx, #0xc8000000
+ orrne \rx, \rx, #0x00b00000
movne \rx, #0xff000000
add \rx,\rx,#3 @ Uart regs are at off set of 3 if
@ byte writes used - Big Endian.
#define IXP4XX_PERIPHERAL_BASE_VIRT (0xFFBF2000)
#define IXP4XX_PERIPHERAL_REGION_SIZE (0x0000C000)
+/*
+ * Debug UART
+ *
+ * This is basically a remap of UART1 into a region that is section
+ * aligned so that it * can be used with the low-level debug code.
+ */
+#define IXP4XX_DEBUG_UART_BASE_PHYS (0xC8000000)
+#define IXP4XX_DEBUG_UART_BASE_VIRT (0xffb00000)
+#define IXP4XX_DEBUG_UART_REGION_SIZE (0x00001000)
+
#define IXP4XX_EXP_CS0_OFFSET 0x00
#define IXP4XX_EXP_CS1_OFFSET 0x04
#define IXP4XX_EXP_CS2_OFFSET 0x08