The PHY is active-low on the MPC85xx CDS and the 8560 ADS just had
the wrong sense for the internal PCI and CPM interrupts.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
reg = <24520 20>;
phy0: ethernet-phy@0 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <0>;
device_type = "ethernet-phy";
};
phy1: ethernet-phy@1 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <1>;
device_type = "ethernet-phy";
};
reg = <24520 20>;
phy0: ethernet-phy@0 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <0>;
device_type = "ethernet-phy";
};
phy1: ethernet-phy@1 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <1>;
device_type = "ethernet-phy";
};
phy2: ethernet-phy@2 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <2>;
device_type = "ethernet-phy";
};
phy3: ethernet-phy@3 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <3>;
device_type = "ethernet-phy";
};
reg = <24520 20>;
phy0: ethernet-phy@0 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <0>;
device_type = "ethernet-phy";
};
phy1: ethernet-phy@1 {
interrupt-parent = <&mpic>;
- interrupts = <5 0>;
+ interrupts = <5 1>;
reg = <1>;
device_type = "ethernet-phy";
};
a800 0 0 4 &mpic 1 1>;
interrupt-parent = <&mpic>;
- interrupts = <18 0>;
+ interrupts = <18 2>;
bus-range = <0 0>;
ranges = <02000000 0 80000000 80000000 0 20000000
01000000 0 00000000 e2000000 0 01000000>;
interrupt-controller;
#address-cells = <0>;
#interrupt-cells = <2>;
- interrupts = <2e 0>;
+ interrupts = <2e 2>;
interrupt-parent = <&mpic>;
reg = <90c00 80>;
built-in;