[SCSI] ipr: Better handle adapter boot time errors

If an ipr adapter encounters an adapter error requiring an
adapter reset to recover from prior to driver load time, the
error will be ignored and recovery will not happen until the
initial timeout occurs waiting for the firmware to come ready,
which means a five minute timeout. Fix is to read the interrupt
register before clearing any of the interrupts at probe time.

Signed-off-by: Brian King <brking@linux.vnet.ibm.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>

diff --git a/drivers/scsi/ipr.c b/drivers/scsi/ipr.c
index b15dfcbde4a06dcb44c12542b95e984f9ca48f10..101e519844df0862c8aca3632baba16fc1847d16 100644 (file)
--- a/drivers/scsi/ipr.c
+++ b/drivers/scsi/ipr.c
@@ -7444,7 +7444,7 @@ static int __devinit ipr_probe_ioa(struct pci_dev *pdev,
        unsigned long ipr_regs_pci;
        void __iomem *ipr_regs;
        int rc = PCIBIOS_SUCCESSFUL;
-       volatile u32 mask, uproc;
+       volatile u32 mask, uproc, interrupts;
 
        ENTER;
 
@@ -7551,9 +7551,14 @@ static int __devinit ipr_probe_ioa(struct pci_dev *pdev,
         * the card is in an unknown state and needs a hard reset
         */
        mask = readl(ioa_cfg->regs.sense_interrupt_mask_reg);
+       interrupts = readl(ioa_cfg->regs.sense_interrupt_reg);
        uproc = readl(ioa_cfg->regs.sense_uproc_interrupt_reg);
        if ((mask & IPR_PCII_HRRQ_UPDATED) == 0 || (uproc & IPR_UPROCI_RESET_ALERT))
                ioa_cfg->needs_hard_reset = 1;
+       if (interrupts & IPR_PCII_ERROR_INTERRUPTS)
+               ioa_cfg->needs_hard_reset = 1;
+       if (interrupts & IPR_PCII_IOA_UNIT_CHECKED)
+               ioa_cfg->ioa_unit_checked = 1;
 
        ipr_mask_and_clear_interrupts(ioa_cfg, ~IPR_PCII_IOA_TRANS_TO_OPER);
        rc = request_irq(pdev->irq, ipr_isr, IRQF_SHARED, IPR_NAME, ioa_cfg);