config W1
tristate "Dallas's 1-wire support"
---help---
- Dallas's 1-wire bus is useful to connect slow 1-pin devices
+ Dallas' 1-wire bus is useful to connect slow 1-pin devices
such as iButtons and thermal sensors.
If you want W1 support, you should say Y here.
This W1 support can also be built as a module. If so, the module
will be called wire.ko.
+config W1_CON
+ depends on CONNECTOR
+ bool "Userspace communication over connector"
+ default y
+ --- help ---
+ This allows to communicate with userspace using connector [Documentation/connector].
+ There are three types of messages between w1 core and userspace:
+ 1. Events. They are generated each time new master or slave device found
+ either due to automatic or requested search.
+ 2. Userspace commands. Includes read/write and search/alarm search comamnds.
+ 3. Replies to userspace commands.
+
source drivers/w1/masters/Kconfig
source drivers/w1/slaves/Kconfig
# Makefile for the Dallas's 1-wire bus.
#
-ifeq ($(CONFIG_CONNECTOR), n)
-EXTRA_CFLAGS += -DNETLINK_DISABLED
-endif
-
ifeq ($(CONFIG_W1_DS2433_CRC), y)
EXTRA_CFLAGS += -DCONFIG_W1_F23_CRC
endif
#include "w1_log.h"
#include "w1_netlink.h"
-#ifndef NETLINK_DISABLED
+#if defined(CONFIG_W1_CON) && (defined(CONFIG_CONNECTOR) || (defined(CONFIG_CONNECTOR_MODULE) && defined(CONFIG_W1_MODULE)))
void w1_netlink_send(struct w1_master *dev, struct w1_netlink_msg *msg)
{
char buf[sizeof(struct cn_msg) + sizeof(struct w1_netlink_msg)];
cn_del_callback(&w1_id);
}
#else
-#warning Netlink support is disabled. Please compile with NET support enabled.
-
void w1_netlink_send(struct w1_master *dev, struct w1_netlink_msg *msg)
{
}