sky2: dont change LED after autoneg

Don't need to change LED's after auto negotiation, the chip
sets them correctly.

Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index eaab3d87dcf34b3fabb3ac340b31813bb973466b..3c08db41cec46f076f28a78424ccd40f6658c74e 100644 (file)
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -1820,29 +1820,6 @@ static void sky2_link_up(struct sky2_port *sky2)
        sky2_write8(hw, SK_REG(port, LNK_LED_REG),
                    LINKLED_ON | LINKLED_BLINK_OFF | LINKLED_LINKSYNC_OFF);
 
-       if (hw->flags & SKY2_HW_NEWER_PHY) {
-               u16 pg = gm_phy_read(hw, port, PHY_MARV_EXT_ADR);
-               u16 led = PHY_M_LEDC_LOS_CTRL(1);       /* link active */
-
-               switch(sky2->speed) {
-               case SPEED_10:
-                       led |= PHY_M_LEDC_INIT_CTRL(7);
-                       break;
-
-               case SPEED_100:
-                       led |= PHY_M_LEDC_STA1_CTRL(7);
-                       break;
-
-               case SPEED_1000:
-                       led |= PHY_M_LEDC_STA0_CTRL(7);
-                       break;
-               }
-
-               gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 3);
-               gm_phy_write(hw, port, PHY_MARV_PHY_CTRL, led);
-               gm_phy_write(hw, port, PHY_MARV_EXT_ADR, pg);
-       }
-
        if (netif_msg_link(sky2))
                printk(KERN_INFO PFX
                       "%s: Link is up at %d Mbps, %s duplex, flow control %s\n",