]> err.no Git - linux-2.6/commitdiff
[PATCH] printk time parameter
authorJan Engelhardt <jengelh@linux01.gwdg.de>
Sun, 25 Jun 2006 12:48:15 +0000 (05:48 -0700)
committerLinus Torvalds <torvalds@g5.osdl.org>
Sun, 25 Jun 2006 17:01:13 +0000 (10:01 -0700)
Currently, enabling/disabling printk timestamps is only possible through
reboot (bootparam) or recompile.  I normally do not run with timestamps
(since syslog handles that in a good manner), but for measuring small
kernel delays (e.g.  irq probing - see parport thread) I needed subsecond
precision, but then again, just for some minutes rather than all kernel
messages to come.  The following patch adds a module_param() with which the
timestamps can be en-/disabled in a live system through
/sys/modules/printk/parameters/printk_time.

Signed-off-by: Jan Engelhardt <jengelh@gmx.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
kernel/printk.c

index 6b89dd9d11b61da9b7e18bad0c6224cbd9eb8013..95b7fe17f124c259a54d0227ac1d0a08ddb62800 100644 (file)
@@ -24,6 +24,7 @@
 #include <linux/console.h>
 #include <linux/init.h>
 #include <linux/module.h>
+#include <linux/moduleparam.h>
 #include <linux/interrupt.h>                   /* For in_interrupt() */
 #include <linux/config.h>
 #include <linux/delay.h>
@@ -439,6 +440,7 @@ static int printk_time = 1;
 #else
 static int printk_time = 0;
 #endif
+module_param(printk_time, int, S_IRUGO | S_IWUSR);
 
 static int __init printk_time_setup(char *str)
 {