hex "Maximum low memory size (in bytes)" if LOWMEM_SIZE_BOOL
default "0x30000000"
+config RELOCATABLE
+ bool "Build a relocatable kernel (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && ADVANCED_OPTIONS && FLATMEM && FSL_BOOKE
+ help
+ This builds a kernel image that is capable of running at the
+ location the kernel is loaded at (some alignment restrictions may
+ exist).
+
+ One use is for the kexec on panic case where the recovery kernel
+ must live at a different physical address than the primary
+ kernel.
+
+ Note: If CONFIG_RELOCATABLE=y, then the kernel runs from the address
+ it has been loaded at and the compile time physical addresses
+ CONFIG_PHYSICAL_START is ignored. However CONFIG_PHYSICAL_START
+ setting can still be useful to bootwrappers that need to know the
+ load location of the kernel (eg. u-boot/mkimage).
+
+config PAGE_OFFSET_BOOL
+ bool "Set custom page offset address"
+ depends on ADVANCED_OPTIONS
+ help
+ This option allows you to set the kernel virtual address at which
+ the kernel will map low memory. This can be useful in optimizing
+ the virtual memory layout of the system.
+
+ Say N here unless you know what you are doing.
+
+config PAGE_OFFSET
+ hex "Virtual address of memory base" if PAGE_OFFSET_BOOL
+ default "0xc0000000"
+
config KERNEL_START_BOOL
bool "Set custom kernel base address"
depends on ADVANCED_OPTIONS
help
This option allows you to set the kernel virtual address at which
- the kernel will map low memory (the kernel image will be linked at
- this address). This can be useful in optimizing the virtual memory
- layout of the system.
+ the kernel will be loaded. Normally this should match PAGE_OFFSET
+ however there are times (like kdump) that one might not want them
+ to be the same.
Say N here unless you know what you are doing.
config KERNEL_START
hex "Virtual address of kernel base" if KERNEL_START_BOOL
+ default PAGE_OFFSET if PAGE_OFFSET_BOOL
+ default "0xc2000000" if CRASH_DUMP
default "0xc0000000"
+config PHYSICAL_START_BOOL
+ bool "Set physical address where the kernel is loaded"
+ depends on ADVANCED_OPTIONS && FLATMEM && FSL_BOOKE
+ help
+ This gives the physical address where the kernel is loaded.
+
+ Say N here unless you know what you are doing.
+
+config PHYSICAL_START
+ hex "Physical address where the kernel is loaded" if PHYSICAL_START_BOOL
+ default "0x02000000" if PPC_STD_MMU && CRASH_DUMP
+ default "0x00000000"
+
+config PHYSICAL_ALIGN
+ hex
+ default "0x10000000" if FSL_BOOKE
+ help
+ This value puts the alignment restrictions on physical address
+ where kernel is loaded and run from. Kernel is compiled for an
+ address which meets above alignment restriction.
+
config TASK_SIZE_BOOL
bool "Set custom user task size"
depends on ADVANCED_OPTIONS
endmenu
if PPC64
+config PAGE_OFFSET
+ hex
+ default "0xc000000000000000"
config KERNEL_START
hex
+ default "0xc000000002000000" if CRASH_DUMP
default "0xc000000000000000"
+config PHYSICAL_START
+ hex
+ default "0x02000000" if CRASH_DUMP
+ default "0x00000000"
endif
source "net/Kconfig"
bl early_init
+#ifdef CONFIG_RELOCATABLE
+ lis r3,kernstart_addr@ha
+ la r3,kernstart_addr@l(r3)
+#ifdef CONFIG_PHYS_64BIT
+ stw r23,0(r3)
+ stw r25,4(r3)
+#else
+ stw r25,0(r3)
+#endif
+#endif
+
mfspr r3,SPRN_TLB1CFG
andi. r3,r3,0xfff
lis r4,num_tlbcam_entries@ha
#include <asm/pci-bridge.h>
#include <asm/phyp_dump.h>
#include <asm/kexec.h>
+#include <mm/mmu_decl.h>
#ifdef DEBUG
#define DBG(fmt...) printk(KERN_ERR fmt)
}
#endif
lmb_add(base, size);
+
+ memstart_addr = min((u64)memstart_addr, base);
}
+
return 0;
}
printk("htab_address = 0x%p\n", htab_address);
printk("htab_hash_mask = 0x%lx\n", htab_hash_mask);
#if PHYSICAL_START > 0
- printk("physical_start = 0x%x\n", PHYSICAL_START);
+ printk("physical_start = 0x%lx\n", PHYSICAL_START);
#endif
printk("-----------------------------------------------------\n");
cam_max_size = max_lowmem_size;
/* adjust lowmem size to max_lowmem_size */
- ram = min(max_lowmem_size, total_lowmem);
+ ram = min(max_lowmem_size, (phys_addr_t)total_lowmem);
/* Calculate CAM values */
__cam0 = 1UL << 2 * (__ilog2(ram) / 2);
unsigned long total_memory;
unsigned long total_lowmem;
-phys_addr_t memstart_addr;
+phys_addr_t memstart_addr = (phys_addr_t)~0ull;
+EXPORT_SYMBOL(memstart_addr);
+phys_addr_t kernstart_addr;
+EXPORT_SYMBOL(kernstart_addr);
phys_addr_t lowmem_end_addr;
int boot_mapsize;
#warning TASK_SIZE is smaller than it needs to be.
#endif
-phys_addr_t memstart_addr;
+phys_addr_t memstart_addr = ~0;
+phys_addr_t kernstart_addr;
void free_initmem(void)
{
unsigned long total_pages;
int boot_mapsize;
- max_pfn = lmb_end_of_DRAM() >> PAGE_SHIFT;
+ max_low_pfn = max_pfn = lmb_end_of_DRAM() >> PAGE_SHIFT;
total_pages = (lmb_end_of_DRAM() - memstart_addr) >> PAGE_SHIFT;
#ifdef CONFIG_HIGHMEM
total_pages = total_lowmem >> PAGE_SHIFT;
start = lmb_alloc(bootmap_pages << PAGE_SHIFT, PAGE_SIZE);
- boot_mapsize = init_bootmem(start >> PAGE_SHIFT, total_pages);
+ min_low_pfn = MEMORY_START >> PAGE_SHIFT;
+ boot_mapsize = init_bootmem_node(NODE_DATA(0), start >> PAGE_SHIFT, min_low_pfn, max_low_pfn);
/* Add active regions with valid PFNs */
for (i = 0; i < lmb.memory.cnt; i++) {
#ifdef CONFIG_CRASH_DUMP
-#define PHYSICAL_START KDUMP_KERNELBASE
#define KDUMP_TRAMPOLINE_START 0x0100
#define KDUMP_TRAMPOLINE_END 0x3000
#define KDUMP_MIN_TCE_ENTRIES 2048
-#else /* !CONFIG_CRASH_DUMP */
-
-#define PHYSICAL_START 0x0
-
#endif /* CONFIG_CRASH_DUMP */
#ifndef __ASSEMBLY__
#include <asm/asm-compat.h>
#include <asm/kdump.h>
+#include <asm/types.h>
/*
* On PPC32 page size is 4K. For PPC64 we support either 4K or 64K software
*
* The kdump dump kernel is one example where KERNELBASE != PAGE_OFFSET.
*
- * To get a physical address from a virtual one you subtract PAGE_OFFSET,
- * _not_ KERNELBASE.
+ * PAGE_OFFSET is the virtual address of the start of lowmem.
+ *
+ * PHYSICAL_START is the physical address of the start of the kernel.
+ *
+ * MEMORY_START is the physical address of the start of lowmem.
+ *
+ * KERNELBASE, PAGE_OFFSET, and PHYSICAL_START are all configurable on
+ * ppc32 and based on how they are set we determine MEMORY_START.
+ *
+ * For the linear mapping the following equation should be true:
+ * KERNELBASE - PAGE_OFFSET = PHYSICAL_START - MEMORY_START
+ *
+ * Also, KERNELBASE >= PAGE_OFFSET and PHYSICAL_START >= MEMORY_START
+ *
+ * There are two was to determine a physical address from a virtual one:
+ * va = pa + PAGE_OFFSET - MEMORY_START
+ * va = pa + KERNELBASE - PHYSICAL_START
*
* If you want to know something's offset from the start of the kernel you
* should subtract KERNELBASE.
* If you want to test if something's a kernel address, use is_kernel_addr().
*/
-#define PAGE_OFFSET ASM_CONST(CONFIG_KERNEL_START)
-#define KERNELBASE (PAGE_OFFSET + PHYSICAL_START)
-#define LOAD_OFFSET PAGE_OFFSET
+#define KERNELBASE ASM_CONST(CONFIG_KERNEL_START)
+#define PAGE_OFFSET ASM_CONST(CONFIG_PAGE_OFFSET)
+#define LOAD_OFFSET ASM_CONST((CONFIG_KERNEL_START-CONFIG_PHYSICAL_START))
+
+#if defined(CONFIG_RELOCATABLE) && defined(CONFIG_FLATMEM)
+#ifndef __ASSEMBLY__
+extern phys_addr_t memstart_addr;
+extern phys_addr_t kernstart_addr;
+#endif
+#define PHYSICAL_START kernstart_addr
+#define MEMORY_START memstart_addr
+#else
+#define PHYSICAL_START ASM_CONST(CONFIG_PHYSICAL_START)
+#define MEMORY_START (PHYSICAL_START + PAGE_OFFSET - KERNELBASE)
+#endif
#ifdef CONFIG_FLATMEM
-#define pfn_valid(pfn) ((pfn) < max_mapnr)
+#define ARCH_PFN_OFFSET (MEMORY_START >> PAGE_SHIFT)
+#define pfn_valid(pfn) ((pfn) >= ARCH_PFN_OFFSET && (pfn) < (ARCH_PFN_OFFSET + max_mapnr))
#endif
#define virt_to_page(kaddr) pfn_to_page(__pa(kaddr) >> PAGE_SHIFT)
#define pfn_to_kaddr(pfn) __va((pfn) << PAGE_SHIFT)
#define virt_addr_valid(kaddr) pfn_valid(__pa(kaddr) >> PAGE_SHIFT)
-#define __va(x) ((void *)((unsigned long)(x) + PAGE_OFFSET))
-#define __pa(x) ((unsigned long)(x) - PAGE_OFFSET)
+#define __va(x) ((void *)((unsigned long)(x) - PHYSICAL_START + KERNELBASE))
+#define __pa(x) ((unsigned long)(x) + PHYSICAL_START - KERNELBASE)
/*
* Unfortunately the PLT is in the BSS in the PPC32 ELF ABI,
#ifndef _ASM_POWERPC_PAGE_32_H
#define _ASM_POWERPC_PAGE_32_H
+#if defined(CONFIG_PHYSICAL_ALIGN) && (CONFIG_PHYSICAL_START != 0)
+#if (CONFIG_PHYSICAL_START % CONFIG_PHYSICAL_ALIGN) != 0
+#error "CONFIG_PHYSICAL_START must be a multiple of CONFIG_PHYSICAL_ALIGN"
+#endif
+#endif
+
#define VM_DATA_DEFAULT_FLAGS VM_DATA_DEFAULT_FLAGS32
#ifdef CONFIG_NOT_COHERENT_CACHE
projects / linux-2.6 / commitdiff