unsigned int hp_detect: 1;
/* gpio lines */
+ unsigned int eapd_mask;
unsigned int gpio_mask;
unsigned int gpio_dir;
unsigned int gpio_data;
for (i = 0; i < cfg->speaker_outs; i++)
stac92xx_reset_pinctl(codec, cfg->speaker_pins[i],
AC_PINCTL_OUT_EN);
+ if (spec->eapd_mask)
+ stac_gpio_set(codec, spec->gpio_mask,
+ spec->gpio_dir, spec->gpio_data &
+ ~spec->eapd_mask);
} else {
/* enable lineouts, disable hp */
for (i = 0; i < cfg->line_outs; i++)
for (i = 0; i < cfg->speaker_outs; i++)
stac92xx_set_pinctl(codec, cfg->speaker_pins[i],
AC_PINCTL_OUT_EN);
+ if (spec->eapd_mask)
+ stac_gpio_set(codec, spec->gpio_mask,
+ spec->gpio_dir, spec->gpio_data |
+ spec->eapd_mask);
}
}
spec->num_dmuxes = ARRAY_SIZE(stac92hd73xx_dmux_nids);
spec->dinput_mux = &stac92hd73xx_dmux;
/* GPIO0 High = Enable EAPD */
- spec->gpio_mask = spec->gpio_dir = 0x1;
+ spec->eapd_mask = spec->gpio_mask = spec->gpio_dir = 0x1;
spec->gpio_data = 0x01;
switch (spec->board_config) {
spec->aloopback_shift = 0;
/* GPIO0 High = EAPD */
- spec->gpio_mask = spec->gpio_dir = spec->gpio_data = 0x1;
+ spec->gpio_mask = 0x01;
+ spec->gpio_dir = 0x01;
+ spec->gpio_mask = 0x01;
+ spec->gpio_data = 0x01;
spec->mux_nids = stac92hd71bxx_mux_nids;
spec->adc_nids = stac92hd71bxx_adc_nids;
case STAC_D965_3ST:
case STAC_D965_5ST:
/* GPIO0 High = Enable EAPD */
- spec->gpio_mask = spec->gpio_dir = 0x01;
+ spec->eapd_mask = spec->gpio_mask = spec->gpio_dir = 0x01;
spec->gpio_data = 0x01;
spec->num_dmics = 0;
/* fallthru */
case STAC_DELL_3ST:
/* GPIO2 High = Enable EAPD */
- spec->gpio_mask = spec->gpio_dir = 0x04;
+ spec->eapd_mask = spec->gpio_mask = spec->gpio_dir = 0x04;
spec->gpio_data = 0x04;
spec->dmic_nids = stac927x_dmic_nids;
spec->num_dmics = STAC927X_NUM_DMICS;
break;
default:
/* GPIO0 High = Enable EAPD */
- spec->gpio_mask = spec->gpio_dir = 0x1;
+ spec->eapd_mask = spec->gpio_mask = spec->gpio_dir = 0x1;
spec->gpio_data = 0x01;
spec->num_dmics = 0;
(AC_USRSP_EN | STAC_HP_EVENT));
spec->gpio_dir = 0x0b;
+ spec->eapd_mask = 0x01;
spec->gpio_mask = 0x1b;
spec->gpio_mute = 0x10;
/* GPIO0 High = EAPD, GPIO1 Low = Headphone Mute,
break;
default:
/* GPIO0 High = EAPD */
- spec->gpio_mask = spec->gpio_dir = 0x1;
+ spec->eapd_mask = spec->gpio_mask = spec->gpio_dir = 0x1;
spec->gpio_data = 0x01;
break;
}