'mdio_reset' has bad side effects that moves the phy_id.
DL10022-based cards work properly without 'mdio_reset'.
Signed-off-by: komurojun-mbn@nifty.com
Signed-off-by: Jeff Garzik <jeff@garzik.org>
SET_ETHTOOL_OPS(dev, &netdev_ethtool_ops);
if (info->flags & (IS_DL10019|IS_DL10022)) {
SET_ETHTOOL_OPS(dev, &netdev_ethtool_ops);
if (info->flags & (IS_DL10019|IS_DL10022)) {
- u_char id = inb(dev->base_addr + 0x1a);
dev->do_ioctl = &ei_ioctl;
mii_phy_probe(dev);
dev->do_ioctl = &ei_ioctl;
mii_phy_probe(dev);
- if ((id == 0x30) && !info->pna_phy && (info->eth_phy == 4))
- info->eth_phy = 0;
}
link->dev_node = &info->node;
}
link->dev_node = &info->node;
-static void mdio_reset(kio_addr_t addr, int phy_id)
-{
- outb_p(0x08, addr);
- outb_p(0x0c, addr);
- outb_p(0x08, addr);
- outb_p(0x0c, addr);
- outb_p(0x00, addr);
-}
-
/*======================================================================
EEPROM access routines for DL10019 and DL10022 based cards
/*======================================================================
EEPROM access routines for DL10019 and DL10022 based cards
}
if (info->flags & IS_DL10022) {
if (info->flags & HAS_MII) {
}
if (info->flags & IS_DL10022) {
if (info->flags & HAS_MII) {
- mdio_reset(nic_base + DLINK_GPIO, info->eth_phy);
+ /* Advertise 100F, 100H, 10F, 10H */
+ mdio_write(nic_base + DLINK_GPIO, info->eth_phy, 4, 0x01e1);
/* Restart MII autonegotiation */
mdio_write(nic_base + DLINK_GPIO, info->eth_phy, 0, 0x0000);
mdio_write(nic_base + DLINK_GPIO, info->eth_phy, 0, 0x1200);
/* Restart MII autonegotiation */
mdio_write(nic_base + DLINK_GPIO, info->eth_phy, 0, 0x0000);
mdio_write(nic_base + DLINK_GPIO, info->eth_phy, 0, 0x1200);