[PATCH] bttv: fix dst i2c read/write timeout failure.

[PATCH] bttv: fix dst i2c read/write timeout failure.

Attached is a patch to bttv which fixes the following problems.

Affected cards and problems:
~~~~~~~~~~~~~~~~~~~~~~~~
o VP-1020 (200103A) Tuning problems, device detection.
o VP-1020 (DST-MOT) Errors during tuning, device detection fails in a while.
o VP-1030 (DST-CI) Tuning sometimes fails after CI commands.
o VP-2031 (DCT-CI) Tuning problems

The timeout happens before the actual timeout occured in the MCU
on the board, and hence the problems.

Changes: (bttv-i2c.diff)
~~~~~~~~~~~~~~~~~~~~~~~~
o Changed the custom wait queue to wait_event_interruptible_timeout()
      - Suggestion by Johannes Stezenbach.

o Fixed the wait queue timeout problem
      - This fixes the timeout problem on various cards.
      - This problem was visible as many
          * Cannot tune to channels, when signal levels are very low.
          * app_info does not work in some conditions for CI based cards
      - Smaller values worked good for newer cards, but the older cards
suffered, settled down to the worst case values that could happen in any
eventuality.

Signed-off-by: Manu Abraham <manu@kromtek.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>