X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=drivers%2Fnet%2Fgianfar.c;h=25bdd0832df5752f4f0de2a23b8df710d0ee83ce;hb=fbe0825752dc34b505777fd59cde4a6ce832eb16;hp=99a4b990939f7720780e02da49d822dbdf2b9abd;hpb=eb855fd8e7f6b1d8b50f24aa36803e29b367b041;p=linux-2.6 diff --git a/drivers/net/gianfar.c b/drivers/net/gianfar.c index 99a4b99093..25bdd0832d 100644 --- a/drivers/net/gianfar.c +++ b/drivers/net/gianfar.c @@ -131,8 +131,6 @@ static void free_skb_resources(struct gfar_private *priv); static void gfar_set_multi(struct net_device *dev); static void gfar_set_hash_for_addr(struct net_device *dev, u8 *addr); static void gfar_configure_serdes(struct net_device *dev); -extern int gfar_local_mdio_write(struct gfar_mii __iomem *regs, int mii_id, int regnum, u16 value); -extern int gfar_local_mdio_read(struct gfar_mii __iomem *regs, int mii_id, int regnum); #ifdef CONFIG_GFAR_NAPI static int gfar_poll(struct napi_struct *napi, int budget); #endif @@ -140,6 +138,7 @@ static int gfar_poll(struct napi_struct *napi, int budget); static void gfar_netpoll(struct net_device *dev); #endif int gfar_clean_rx_ring(struct net_device *dev, int rx_work_limit); +static int gfar_clean_tx_ring(struct net_device *dev); static int gfar_process_frame(struct net_device *dev, struct sk_buff *skb, int length); static void gfar_vlan_rx_register(struct net_device *netdev, struct vlan_group *grp); @@ -477,24 +476,30 @@ static int init_phy(struct net_device *dev) return 0; } +/* + * Initialize TBI PHY interface for communicating with the + * SERDES lynx PHY on the chip. We communicate with this PHY + * through the MDIO bus on each controller, treating it as a + * "normal" PHY at the address found in the TBIPA register. We assume + * that the TBIPA register is valid. Either the MDIO bus code will set + * it to a value that doesn't conflict with other PHYs on the bus, or the + * value doesn't matter, as there are no other PHYs on the bus. + */ static void gfar_configure_serdes(struct net_device *dev) { struct gfar_private *priv = netdev_priv(dev); struct gfar_mii __iomem *regs = (void __iomem *)&priv->regs->gfar_mii_regs; + int tbipa = gfar_read(&priv->regs->tbipa); - /* Initialise TBI i/f to communicate with serdes (lynx phy) */ - - /* Single clk mode, mii mode off(for aerdes communication) */ - gfar_local_mdio_write(regs, TBIPA_VALUE, MII_TBICON, TBICON_CLK_SELECT); + /* Single clk mode, mii mode off(for serdes communication) */ + gfar_local_mdio_write(regs, tbipa, MII_TBICON, TBICON_CLK_SELECT); - /* Supported pause and full-duplex, no half-duplex */ - gfar_local_mdio_write(regs, TBIPA_VALUE, MII_ADVERTISE, + gfar_local_mdio_write(regs, tbipa, MII_ADVERTISE, ADVERTISE_1000XFULL | ADVERTISE_1000XPAUSE | ADVERTISE_1000XPSE_ASYM); - /* ANEG enable, restart ANEG, full duplex mode, speed[1] set */ - gfar_local_mdio_write(regs, TBIPA_VALUE, MII_BMCR, BMCR_ANENABLE | + gfar_local_mdio_write(regs, tbipa, MII_BMCR, BMCR_ANENABLE | BMCR_ANRESTART | BMCR_FULLDPLX | BMCR_SPEED1000); } @@ -541,9 +546,6 @@ static void init_registers(struct net_device *dev) /* Initialize the Minimum Frame Length Register */ gfar_write(&priv->regs->minflr, MINFLR_INIT_SETTINGS); - - /* Assign the TBI an address which won't conflict with the PHYs */ - gfar_write(&priv->regs->tbipa, TBIPA_VALUE); } @@ -633,6 +635,8 @@ static void free_skb_resources(struct gfar_private *priv) dev_kfree_skb_any(priv->tx_skbuff[i]); priv->tx_skbuff[i] = NULL; } + + txbdp++; } kfree(priv->tx_skbuff); @@ -1140,7 +1144,7 @@ static int gfar_close(struct net_device *dev) } /* Changes the mac address if the controller is not running. */ -int gfar_set_mac_address(struct net_device *dev) +static int gfar_set_mac_address(struct net_device *dev) { gfar_set_mac_for_addr(dev, 0, dev->dev_addr); @@ -1259,7 +1263,7 @@ static void gfar_timeout(struct net_device *dev) } /* Interrupt Handler for Transmit complete */ -int gfar_clean_tx_ring(struct net_device *dev) +static int gfar_clean_tx_ring(struct net_device *dev) { struct txbd8 *bdp; struct gfar_private *priv = netdev_priv(dev);