X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=drivers%2Fmtd%2Fnand%2Fatmel_nand.c;h=99aec46e21450565e3e323adccfcb1f077597511;hb=a1b81a84fff05dbfef45b7012c26e1fee9973e5d;hp=4814fc9b237bffe0091defd9922a395b0e3465fd;hpb=23a346ca4a5a6f50f81062456af955155f68e313;p=linux-2.6

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 4814fc9b23..99aec46e21 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -33,6 +33,7 @@
 #include <linux/io.h>
 
 #include <asm/arch/board.h>
+#include <asm/arch/cpu.h>
 
 #ifdef CONFIG_MTD_NAND_ATMEL_ECC_HW
 #define hard_ecc	1
@@ -264,6 +265,19 @@ static int atmel_nand_read_page(struct mtd_info *mtd,
 	uint8_t *ecc_pos;
 	int stat;
 
+	/*
+	 * Errata: ALE is incorrectly wired up to the ECC controller
+	 * on the AP7000, so it will include the address cycles in the
+	 * ECC calculation.
+	 *
+	 * Workaround: Reset the parity registers before reading the
+	 * actual data.
+	 */
+	if (cpu_is_at32ap7000()) {
+		struct atmel_nand_host *host = chip->priv;
+		ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
+	}
+
 	/* read the page */
 	chip->read_buf(mtd, p, eccsize);
 
@@ -377,9 +391,16 @@ static int atmel_nand_correct(struct mtd_info *mtd, u_char *dat,
 }
 
 /*
- * Enable HW ECC : unsused
+ * Enable HW ECC : unused on most chips
  */
-static void atmel_nand_hwctl(struct mtd_info *mtd, int mode) { ; }
+static void atmel_nand_hwctl(struct mtd_info *mtd, int mode)
+{
+	if (cpu_is_at32ap7000()) {
+		struct nand_chip *nand_chip = mtd->priv;
+		struct atmel_nand_host *host = nand_chip->priv;
+		ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
+	}
+}
 
 #ifdef CONFIG_MTD_PARTITIONS
 static const char *part_probes[] = { "cmdlinepart", NULL };