X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=drivers%2Fmtd%2Fnand%2Fatmel_nand.c;h=3387e0d5076b06bad1af8506d73f673db99a1d2a;hb=HEAD;hp=50700ab5a57ab3fb2f37dbb1f0b187c1f90740c9;hpb=90574d0a4d4b73308ae54a2a57a4f3f1fa98e984;p=linux-2.6

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 50700ab5a5..3387e0d507 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -32,7 +32,8 @@
 #include <linux/gpio.h>
 #include <linux/io.h>
 
-#include <asm/arch/board.h>
+#include <mach/board.h>
+#include <mach/cpu.h>
 
 #ifdef CONFIG_MTD_NAND_ATMEL_ECC_HW
 #define hard_ecc	1
@@ -141,6 +142,37 @@ static int atmel_nand_device_ready(struct mtd_info *mtd)
 	return gpio_get_value(host->board->rdy_pin);
 }
 
+/*
+ * Minimal-overhead PIO for data access.
+ */
+static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
+{
+	struct nand_chip	*nand_chip = mtd->priv;
+
+	__raw_readsb(nand_chip->IO_ADDR_R, buf, len);
+}
+
+static void atmel_read_buf16(struct mtd_info *mtd, u8 *buf, int len)
+{
+	struct nand_chip	*nand_chip = mtd->priv;
+
+	__raw_readsw(nand_chip->IO_ADDR_R, buf, len / 2);
+}
+
+static void atmel_write_buf(struct mtd_info *mtd, const u8 *buf, int len)
+{
+	struct nand_chip	*nand_chip = mtd->priv;
+
+	__raw_writesb(nand_chip->IO_ADDR_W, buf, len);
+}
+
+static void atmel_write_buf16(struct mtd_info *mtd, const u8 *buf, int len)
+{
+	struct nand_chip	*nand_chip = mtd->priv;
+
+	__raw_writesw(nand_chip->IO_ADDR_W, buf, len / 2);
+}
+
 /*
  * write oob for small pages
  */
@@ -233,6 +265,19 @@ static int atmel_nand_read_page(struct mtd_info *mtd,
 	uint8_t *ecc_pos;
 	int stat;
 
+	/*
+	 * Errata: ALE is incorrectly wired up to the ECC controller
+	 * on the AP7000, so it will include the address cycles in the
+	 * ECC calculation.
+	 *
+	 * Workaround: Reset the parity registers before reading the
+	 * actual data.
+	 */
+	if (cpu_is_at32ap7000()) {
+		struct atmel_nand_host *host = chip->priv;
+		ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
+	}
+
 	/* read the page */
 	chip->read_buf(mtd, p, eccsize);
 
@@ -346,9 +391,16 @@ static int atmel_nand_correct(struct mtd_info *mtd, u_char *dat,
 }
 
 /*
- * Enable HW ECC : unsused
+ * Enable HW ECC : unused on most chips
  */
-static void atmel_nand_hwctl(struct mtd_info *mtd, int mode) { ; }
+static void atmel_nand_hwctl(struct mtd_info *mtd, int mode)
+{
+	if (cpu_is_at32ap7000()) {
+		struct nand_chip *nand_chip = mtd->priv;
+		struct atmel_nand_host *host = nand_chip->priv;
+		ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
+	}
+}
 
 #ifdef CONFIG_MTD_PARTITIONS
 static const char *part_probes[] = { "cmdlinepart", NULL };
@@ -436,8 +488,14 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
 
 	nand_chip->chip_delay = 20;		/* 20us command delay time */
 
-	if (host->board->bus_width_16)		/* 16-bit bus width */
+	if (host->board->bus_width_16) {	/* 16-bit bus width */
 		nand_chip->options |= NAND_BUSWIDTH_16;
+		nand_chip->read_buf = atmel_read_buf16;
+		nand_chip->write_buf = atmel_write_buf16;
+	} else {
+		nand_chip->read_buf = atmel_read_buf;
+		nand_chip->write_buf = atmel_write_buf;
+	}
 
 	platform_set_drvdata(pdev, host);
 	atmel_nand_enable(host);
@@ -546,7 +604,7 @@ err_nand_ioremap:
 /*
  * Remove a NAND device.
  */
-static int __devexit atmel_nand_remove(struct platform_device *pdev)
+static int __exit atmel_nand_remove(struct platform_device *pdev)
 {
 	struct atmel_nand_host *host = platform_get_drvdata(pdev);
 	struct mtd_info *mtd = &host->mtd;
@@ -564,8 +622,7 @@ static int __devexit atmel_nand_remove(struct platform_device *pdev)
 }
 
 static struct platform_driver atmel_nand_driver = {
-	.probe		= atmel_nand_probe,
-	.remove		= atmel_nand_remove,
+	.remove		= __exit_p(atmel_nand_remove),
 	.driver		= {
 		.name	= "atmel_nand",
 		.owner	= THIS_MODULE,
@@ -574,7 +631,7 @@ static struct platform_driver atmel_nand_driver = {
 
 static int __init atmel_nand_init(void)
 {
-	return platform_driver_register(&atmel_nand_driver);
+	return platform_driver_probe(&atmel_nand_driver, atmel_nand_probe);
 }