X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=arch%2Fpowerpc%2FKconfig.debug;h=6a79fe43e229e9036a25b8792eb45246f44db30c;hb=57c351de715458f8fbee1e92e8cc65ddc00da04c;hp=c38bc22370571cc2a92e734ffff205508e52c3d9;hpb=ab3e975e7c8b5efb452bdb0d06c1cb7399f83979;p=linux-2.6

diff --git a/arch/powerpc/Kconfig.debug b/arch/powerpc/Kconfig.debug
index c38bc22370..6a79fe43e2 100644
--- a/arch/powerpc/Kconfig.debug
+++ b/arch/powerpc/Kconfig.debug
@@ -144,7 +144,7 @@ config BDI_SWITCH
 
 config BOOTX_TEXT
 	bool "Support for early boot text console (BootX or OpenFirmware only)"
-	depends PPC_OF && PPC_MULTIPLATFORM
+	depends on PPC_OF && PPC_MULTIPLATFORM
 	help
 	  Say Y here to see progress messages from the boot firmware in text
 	  mode. Requires either BootX or Open Firmware.
@@ -216,21 +216,41 @@ config PPC_EARLY_DEBUG_BEAT
 config PPC_EARLY_DEBUG_44x
 	bool "Early serial debugging for IBM/AMCC 44x CPUs"
 	depends on 44x
-	select PPC_UDBG_16550
 	help
 	  Select this to enable early debugging for IBM 44x chips via the
 	  inbuilt serial port.
 
+config PPC_EARLY_DEBUG_CPM
+	bool "Early serial debugging for Freescale CPM-based serial ports"
+	depends on SERIAL_CPM
+	select PIN_TLB if PPC_8xx
+	help
+	  Select this to enable early debugging for Freescale chips
+	  using a CPM-based serial port.  This assumes that the bootwrapper
+	  has run, and set up the CPM in a particular way.
+
 endchoice
 
 config PPC_EARLY_DEBUG_44x_PHYSLOW
 	hex "Low 32 bits of early debug UART physical address"
-	depends PPC_EARLY_DEBUG_44x
+	depends on PPC_EARLY_DEBUG_44x
 	default "0x40000200"
 
 config PPC_EARLY_DEBUG_44x_PHYSHIGH
 	hex "EPRN of early debug UART physical address"
-	depends PPC_EARLY_DEBUG_44x
+	depends on PPC_EARLY_DEBUG_44x
 	default "0x1"
 
+config PPC_EARLY_DEBUG_CPM_ADDR
+	hex "CPM UART early debug transmit descriptor address"
+	depends on PPC_EARLY_DEBUG_CPM
+	default "0xfa202008" if PPC_EP88XC
+	default "0xf0000008" if CPM2
+	default "0xff002008" if CPM1
+	help
+	  This specifies the address of the transmit descriptor
+	  used for early debug output.  Because it is needed before
+	  platform probing is done, all platforms selected must
+	  share the same address.
+
 endmenu