X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=Documentation%2Fvideo4linux%2Fet61x251.txt;h=1247566c4de38211458144eb206432db0a8698d0;hb=7742c0bc8594cf1bcbad1f3e876acae5b644dc7b;hp=b65aa0fa18489b6bdcdf062a93ba5b9328da2bf9;hpb=2fe0ae78c6975d6fa2fc0c84f2b8944543054105;p=linux-2.6

diff --git a/Documentation/video4linux/et61x251.txt b/Documentation/video4linux/et61x251.txt
index b65aa0fa18..1247566c4d 100644
--- a/Documentation/video4linux/et61x251.txt
+++ b/Documentation/video4linux/et61x251.txt
@@ -23,7 +23,7 @@ Index
 
 1. Copyright
 ============
-Copyright (C) 2006 by Luca Risolia <luca.risolia@studio.unibo.it>
+Copyright (C) 2006-2007 by Luca Risolia <luca.risolia@studio.unibo.it>
 
 
 2. Disclaimer
@@ -135,8 +135,9 @@ And finally:
 6. Module loading
 =================
 To use the driver, it is necessary to load the "et61x251" module into memory
-after every other module required: "videodev", "usbcore" and, depending on
-the USB host controller you have, "ehci-hcd", "uhci-hcd" or "ohci-hcd".
+after every other module required: "videodev", "v4l2_common", "compat_ioctl32",
+"usbcore" and, depending on the USB host controller you have, "ehci-hcd",
+"uhci-hcd" or "ohci-hcd".
 
 Loading can be done as shown below:
 
@@ -222,7 +223,7 @@ identifier - of the camera registered as "/dev/video0":
 	[root@localhost #] echo 1 > i2c_reg
 	[root@localhost #] cat i2c_val
 
-Note that if the sensor registers can not be read, "cat" will fail.
+Note that if the sensor registers cannot be read, "cat" will fail.
 To avoid race conditions, all the I/O accesses to the files are serialized.