X-Git-Url: https://err.no/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=Documentation%2FMSI-HOWTO.txt;h=0d8240774fca2d3bc00454ce5bc65ec20fe09e2e;hb=b5457b7bdf284d683880163a4c59fdde2f84325a;hp=5c34910665d1d8514fb77c07e310f91b2b7f59bd;hpb=0bd2af46839ad6262d25714a6ec0365db9d6b98f;p=linux-2.6

diff --git a/Documentation/MSI-HOWTO.txt b/Documentation/MSI-HOWTO.txt
index 5c34910665..0d8240774f 100644
--- a/Documentation/MSI-HOWTO.txt
+++ b/Documentation/MSI-HOWTO.txt
@@ -219,7 +219,7 @@ into the field vector of each element contained in a second argument.
 Note that the pre-assigned IOAPIC dev->irq is valid only if the device
 operates in PIN-IRQ assertion mode. In MSI-X mode, any attempt at
 using dev->irq by the device driver to request for interrupt service
-may result unpredictabe behavior.
+may result in unpredictable behavior.
 
 For each MSI-X vector granted, a device driver is responsible for calling
 other functions like request_irq(), enable_irq(), etc. to enable
@@ -480,8 +480,8 @@ The PCI stack provides 3 possible levels of MSI disabling:
 
 6.1. Disabling MSI on a single device
 
-Under some circumstances, it might be required to disable MSI on a
-single device, It may be achived by either not calling pci_enable_msi()
+Under some circumstances it might be required to disable MSI on a
+single device.  This may be achieved by either not calling pci_enable_msi()
 or all, or setting the pci_dev->no_msi flag before (most of the time
 in a quirk).
 
@@ -492,7 +492,7 @@ being able to route MSI between busses. In this case, MSI have to be
 disabled on all devices behind this bridge. It is achieves by setting
 the PCI_BUS_FLAGS_NO_MSI flag in the pci_bus->bus_flags of the bridge
 subordinate bus. There is no need to set the same flag on bridges that
-are below the broken brigde. When pci_enable_msi() is called to enable
+are below the broken bridge. When pci_enable_msi() is called to enable
 MSI on a device, pci_msi_supported() takes care of checking the NO_MSI
 flag in all parent busses of the device.