menu "Core Netfilter Configuration"
- depends on NET && NETFILTER
+ depends on NET && INET && NETFILTER
config NETFILTER_NETLINK
tristate "Netfilter netlink interface"
depends on NF_CONNTRACK_ENABLED
config NF_CONNTRACK_SUPPORT
- bool "Layer 3 Independent Connection tracking (EXPERIMENTAL)"
- depends on EXPERIMENTAL
+ bool "Layer 3 Independent Connection tracking"
help
Layer 3 independent connection tracking is experimental scheme
which generalize ip_conntrack to support other layer 3 protocols.
below).
config IP_NF_CONNTRACK_SUPPORT
- bool "Layer 3 Dependent Connection tracking"
+ bool "Layer 3 Dependent Connection tracking (OBSOLETE)"
help
The old, Layer 3 dependent ip_conntrack subsystem of netfilter.
If unsure, say `N'.
+config NF_CT_PROTO_GRE
+ tristate
+ depends on NF_CONNTRACK
+
config NF_CT_PROTO_SCTP
- tristate 'SCTP protocol on new connection tracking support (EXPERIMENTAL)'
+ tristate 'SCTP protocol connection tracking support (EXPERIMENTAL)'
depends on EXPERIMENTAL && NF_CONNTRACK
default n
help
Documentation/modules.txt. If unsure, say `N'.
config NF_CONNTRACK_AMANDA
- tristate "Amanda backup protocol support (EXPERIMENTAL)"
- depends on EXPERIMENTAL && NF_CONNTRACK
+ tristate "Amanda backup protocol support"
+ depends on NF_CONNTRACK
select TEXTSEARCH
select TEXTSEARCH_KMP
help
To compile it as a module, choose M here. If unsure, say N.
config NF_CONNTRACK_FTP
- tristate "FTP support on new connection tracking (EXPERIMENTAL)"
- depends on EXPERIMENTAL && NF_CONNTRACK
+ tristate "FTP protocol support"
+ depends on NF_CONNTRACK
help
Tracking FTP connections is problematic: special helpers are
required for tracking them, and doing masquerading and other forms
To compile it as a module, choose M here. If unsure, say N.
+config NF_CONNTRACK_H323
+ tristate "H.323 protocol support (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && NF_CONNTRACK && (IPV6 || IPV6=n)
+ help
+ H.323 is a VoIP signalling protocol from ITU-T. As one of the most
+ important VoIP protocols, it is widely used by voice hardware and
+ software including voice gateways, IP phones, Netmeeting, OpenPhone,
+ Gnomemeeting, etc.
+
+ With this module you can support H.323 on a connection tracking/NAT
+ firewall.
+
+ This module supports RAS, Fast Start, H.245 Tunnelling, Call
+ Forwarding, RTP/RTCP and T.120 based audio, video, fax, chat,
+ whiteboard, file transfer, etc. For more information, please
+ visit http://nath323.sourceforge.net/.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_IRC
+ tristate "IRC protocol support"
+ depends on NF_CONNTRACK
+ help
+ There is a commonly-used extension to IRC called
+ Direct Client-to-Client Protocol (DCC). This enables users to send
+ files to each other, and also chat to each other without the need
+ of a server. DCC Sending is used anywhere you send files over IRC,
+ and DCC Chat is most commonly used by Eggdrop bots. If you are
+ using NAT, this extension will enable you to send files and initiate
+ chats. Note that you do NOT need this extension to get files or
+ have others initiate chats, or everything else in IRC.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_NETBIOS_NS
+ tristate "NetBIOS name service protocol support (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && NF_CONNTRACK
+ help
+ NetBIOS name service requests are sent as broadcast messages from an
+ unprivileged port and responded to with unicast messages to the
+ same port. This make them hard to firewall properly because connection
+ tracking doesn't deal with broadcasts. This helper tracks locally
+ originating NetBIOS name service requests and the corresponding
+ responses. It relies on correct IP address configuration, specifically
+ netmask and broadcast address. When properly configured, the output
+ of "ip address show" should look similar to this:
+
+ $ ip -4 address show eth0
+ 4: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000
+ inet 172.16.2.252/24 brd 172.16.2.255 scope global eth0
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_PPTP
+ tristate "PPtP protocol support"
+ depends on NF_CONNTRACK
+ select NF_CT_PROTO_GRE
+ help
+ This module adds support for PPTP (Point to Point Tunnelling
+ Protocol, RFC2637) connection tracking and NAT.
+
+ If you are running PPTP sessions over a stateful firewall or NAT
+ box, you may want to enable this feature.
+
+ Please note that not all PPTP modes of operation are supported yet.
+ Specifically these limitations exist:
+ - Blindy assumes that control connections are always established
+ in PNS->PAC direction. This is a violation of RFC2637.
+ - Only supports a single call within each session
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_SANE
+ tristate "SANE protocol support (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && NF_CONNTRACK
+ help
+ SANE is a protocol for remote access to scanners as implemented
+ by the 'saned' daemon. Like FTP, it uses separate control and
+ data connections.
+
+ With this module you can support SANE on a connection tracking
+ firewall.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_SIP
+ tristate "SIP protocol support (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && NF_CONNTRACK
+ help
+ SIP is an application-layer control protocol that can establish,
+ modify, and terminate multimedia sessions (conferences) such as
+ Internet telephony calls. With the ip_conntrack_sip and
+ the nf_nat_sip modules you can support the protocol on a connection
+ tracking/NATing firewall.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_TFTP
+ tristate "TFTP protocol support"
+ depends on NF_CONNTRACK
+ help
+ TFTP connection tracking helper, this is required depending
+ on how restrictive your ruleset is.
+ If you are using a tftp client behind -j SNAT or -j MASQUERADING
+ you will need this.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
config NF_CT_NETLINK
tristate 'Connection tracking netlink interface (EXPERIMENTAL)'
depends on EXPERIMENTAL && NF_CONNTRACK && NETFILTER_NETLINK
tristate '"CONNMARK" target support'
depends on NETFILTER_XTABLES
depends on IP_NF_MANGLE || IP6_NF_MANGLE
- depends on (IP_NF_CONNTRACK && IP_NF_CONNTRACK_MARK) || (NF_CONNTRACK_MARK && NF_CONNTRACK)
+ depends on IP_NF_CONNTRACK || NF_CONNTRACK
+ select IP_NF_CONNTRACK_MARK if IP_NF_CONNTRACK
+ select NF_CONNTRACK_MARK if NF_CONNTRACK
help
This option adds a `CONNMARK' target, which allows one to manipulate
the connection mark value. Similar to the MARK target, but
To compile it as a module, choose M here. If unsure, say N.
+config NETFILTER_XT_TARGET_TCPMSS
+ tristate '"TCPMSS" target support'
+ depends on NETFILTER_XTABLES && (IPV6 || IPV6=n)
+ ---help---
+ This option adds a `TCPMSS' target, which allows you to alter the
+ MSS value of TCP SYN packets, to control the maximum size for that
+ connection (usually limiting it to your outgoing interface's MTU
+ minus 40).
+
+ This is used to overcome criminally braindead ISPs or servers which
+ block ICMP Fragmentation Needed packets. The symptoms of this
+ problem are that everything works fine from your Linux
+ firewall/router, but machines behind it can never exchange large
+ packets:
+ 1) Web browsers connect, then hang with no data received.
+ 2) Small mail works fine, but large emails hang.
+ 3) ssh works fine, but scp hangs after initial handshaking.
+
+ Workaround: activate this option and add a rule to your firewall
+ configuration like:
+
+ iptables -A FORWARD -p tcp --tcp-flags SYN,RST SYN \
+ -j TCPMSS --clamp-mss-to-pmtu
+
+ To compile it as a module, choose M here. If unsure, say N.
+
config NETFILTER_XT_MATCH_COMMENT
tristate '"comment" match support'
depends on NETFILTER_XTABLES
config NETFILTER_XT_MATCH_CONNBYTES
tristate '"connbytes" per-connection counter match support'
depends on NETFILTER_XTABLES
- depends on (IP_NF_CONNTRACK && IP_NF_CT_ACCT) || (NF_CT_ACCT && NF_CONNTRACK)
+ depends on IP_NF_CONNTRACK || NF_CONNTRACK
+ select IP_NF_CT_ACCT if IP_NF_CONNTRACK
+ select NF_CT_ACCT if NF_CONNTRACK
help
This option adds a `connbytes' match, which allows you to match the
number of bytes and/or packets for each direction within a connection.
config NETFILTER_XT_MATCH_CONNMARK
tristate '"connmark" connection mark match support'
depends on NETFILTER_XTABLES
- depends on (IP_NF_CONNTRACK && IP_NF_CONNTRACK_MARK) || (NF_CONNTRACK_MARK && NF_CONNTRACK)
+ depends on IP_NF_CONNTRACK || NF_CONNTRACK
+ select IP_NF_CONNTRACK_MARK if IP_NF_CONNTRACK
+ select NF_CONNTRACK_MARK if NF_CONNTRACK
help
This option adds a `connmark' match, which allows you to match the
connection mark value previously set for the session by `CONNMARK'.
config NETFILTER_XT_MATCH_HASHLIMIT
tristate '"hashlimit" match support'
- depends on NETFILTER_XTABLES
+ depends on NETFILTER_XTABLES && (IP6_NF_IPTABLES || IP6_NF_IPTABLES=n)
help
This option adds a `hashlimit' match.
projects / linux-2.6 / blobdiff