* @aid: association ID number, valid only when @assoc is true
* @use_cts_prot: use CTS protection
* @use_short_preamble: use 802.11b short preamble
+ * @dtim_period: num of beacons before the next DTIM, for PSM
* @timestamp: beacon timestamp
* @beacon_int: beacon interval
- * @assoc_capability: capabbilities taken from assoc resp
+ * @assoc_capability: capabilities taken from assoc resp
* @assoc_ht: association in HT mode
* @ht_conf: ht capabilities
* @ht_bss_conf: ht extended capabilities
/* erp related data */
bool use_cts_prot;
bool use_short_preamble;
+ u8 dtim_period;
u16 beacon_int;
u16 assoc_capability;
u64 timestamp;
* @radio_enabled: when zero, driver is required to switch off the radio.
* TODO make a flag
* @beacon_int: beacon interval (TODO make interface config)
+ * @listen_interval: listen interval in units of beacon interval
* @flags: configuration flags defined above
* @power_level: requested transmit power (in dBm)
* @max_antenna_gain: maximum antenna gain (in dBi)
int radio_enabled;
int beacon_int;
+ u16 listen_interval;
u32 flags;
int power_level;
int max_antenna_gain;
* @max_signal: Maximum value for signal (rssi) in RX information, used
* only when @IEEE80211_HW_SIGNAL_UNSPEC or @IEEE80211_HW_SIGNAL_DB
*
+ * @max_listen_interval: max listen interval in units of beacon interval
+ * that HW supports
+ *
* @queues: number of available hardware transmit queues for
* data packets. WMM/QoS requires at least four, these
* queues need to have configurable access parameters.
unsigned int extra_tx_headroom;
int channel_change_time;
int vif_data_size;
- u16 queues, ampdu_queues;
+ u16 queues;
+ u16 ampdu_queues;
+ u16 max_listen_interval;
s8 max_signal;
};