struct pci_error_handlers *err_handler;
struct device_driver driver;
struct pci_dynids dynids;
+
+ int multithread_probe;
};
#define to_pci_driver(drv) container_of(drv,struct pci_driver, driver)
struct pci_dev * pci_scan_single_device(struct pci_bus *bus, int devfn);
void pci_device_add(struct pci_dev *dev, struct pci_bus *bus);
unsigned int pci_scan_child_bus(struct pci_bus *bus);
-void pci_bus_add_device(struct pci_dev *dev);
+int __must_check pci_bus_add_device(struct pci_dev *dev);
void pci_read_bridge_bases(struct pci_bus *child);
struct resource *pci_find_parent_resource(const struct pci_dev *dev, struct resource *res);
int pci_get_interrupt_pin(struct pci_dev *dev, struct pci_dev **bridge);
extern void pci_dev_put(struct pci_dev *dev);
extern void pci_remove_bus(struct pci_bus *b);
extern void pci_remove_bus_device(struct pci_dev *dev);
+extern void pci_stop_bus_device(struct pci_dev *dev);
void pci_setup_cardbus(struct pci_bus *bus);
/* Generic PCI functions exported to card drivers */
u16 entry; /* driver uses to specify entry, OS writes */
};
+struct msi_msg {
+ u32 address_lo; /* low 32 bits of msi message address */
+ u32 address_hi; /* high 32 bits of msi message address */
+ u32 data; /* 16 bits of msi message data */
+};
+
#ifndef CONFIG_PCI_MSI
static inline void pci_scan_msi_device(struct pci_dev *dev) {}
static inline int pci_enable_msi(struct pci_dev *dev) {return -1;}
struct msix_entry *entries, int nvec);
extern void pci_disable_msix(struct pci_dev *dev);
extern void msi_remove_pci_irq_vectors(struct pci_dev *dev);
+
+/*
+ * MSI operation vector. Used by the msi core code (drivers/pci/msi.c)
+ * to abstract platform-specific tasks relating to MSI address generation
+ * and resource management.
+ */
+struct msi_ops {
+ int needs_64bit_address;
+ /**
+ * setup - generate an MSI bus address and data for a given vector
+ * @pdev: PCI device context (in)
+ * @irq: irq allocated by the msi core (in)
+ * @msg: PCI bus address and data for msi message (out)
+ *
+ * Description: The setup op is used to generate a PCI bus addres and
+ * data which the msi core will program into the card MSI capability
+ * registers. The setup routine is responsible for picking an initial
+ * cpu to target the MSI at. The setup routine is responsible for
+ * examining pdev to determine the MSI capabilities of the card and
+ * generating a suitable address/data. The setup routine is
+ * responsible for allocating and tracking any system resources it
+ * needs to route the MSI to the cpu it picks, and for associating
+ * those resources with the passed in vector.
+ *
+ * Returns 0 if the MSI address/data was successfully setup.
+ **/
+
+ int (*setup) (struct pci_dev *pdev, unsigned int irq,
+ struct msi_msg *msg);
+
+ /**
+ * teardown - release resources allocated by setup
+ * @vector: vector context for resources (in)
+ *
+ * Description: The teardown op is used to release any resources
+ * that were allocated in the setup routine associated with the passed
+ * in vector.
+ **/
+
+ void (*teardown) (unsigned int irq);
+
+ /**
+ * target - retarget an MSI at a different cpu
+ * @vector: vector context for resources (in)
+ * @cpu: new cpu to direct vector at (in)
+ * @addr_hi: new value of PCI bus upper 32 bits (in/out)
+ * @addr_lo: new value of PCI bus lower 32 bits (in/out)
+ *
+ * Description: The target op is used to redirect an MSI vector
+ * at a different cpu. addr_hi/addr_lo coming in are the existing
+ * values that the MSI core has programmed into the card. The
+ * target code is responsible for freeing any resources (if any)
+ * associated with the old address, and generating a new PCI bus
+ * addr_hi/addr_lo that will redirect the vector at the indicated cpu.
+ **/
+
+ void (*target) (unsigned int irq, cpumask_t cpumask,
+ struct msi_msg *msg);
+};
+
+extern int msi_register(struct msi_ops *ops);
+
#endif
+#ifdef CONFIG_HT_IRQ
+/* Helper functions.. */
+void write_ht_irq_low(unsigned int irq, u32 data);
+void write_ht_irq_high(unsigned int irq, u32 data);
+u32 read_ht_irq_low(unsigned int irq);
+u32 read_ht_irq_high(unsigned int irq);
+void mask_ht_irq(unsigned int irq);
+void unmask_ht_irq(unsigned int irq);
+
+/* The functions a driver should call */
+int ht_create_irq(struct pci_dev *dev, int idx);
+void ht_destroy_irq(unsigned int irq);
+
+/* The arch hook for getting things started */
+int arch_setup_ht_irq(unsigned int irq, struct pci_dev *dev);
+#endif /* CONFIG_HT_IRQ */
+
extern void pci_block_user_cfg_access(struct pci_dev *dev);
extern void pci_unblock_user_cfg_access(struct pci_dev *dev);
void pci_fixup_device(enum pci_fixup_pass pass, struct pci_dev *dev);
extern int pci_pci_problems;
-#define PCIPCI_FAIL 1
+#define PCIPCI_FAIL 1 /* No PCI PCI DMA */
#define PCIPCI_TRITON 2
#define PCIPCI_NATOMA 4
#define PCIPCI_VIAETBF 8
#define PCIPCI_VSFX 16
-#define PCIPCI_ALIMAGIK 32
+#define PCIPCI_ALIMAGIK 32 /* Need low latency setting */
+#define PCIAGP_FAIL 64 /* No PCI to AGP DMA */
#endif /* __KERNEL__ */
#endif /* LINUX_PCI_H */
projects / linux-2.6 / blobdiff