ATA_DEF_BUSY_WAIT = 10000,
ATA_SHORT_PAUSE = (HZ >> 6) + 1,
+ ATAPI_MAX_DRAIN = 16 << 10,
+
ATA_SHT_EMULATED = 1,
ATA_SHT_CMD_PER_LUN = 1,
ATA_SHT_THIS_ID = -1,
ATA_DFLAG_ACPI_PENDING = (1 << 5), /* ACPI resume action pending */
ATA_DFLAG_ACPI_FAILED = (1 << 6), /* ACPI on devcfg has failed */
ATA_DFLAG_AN = (1 << 7), /* AN configured */
+ ATA_DFLAG_HIPM = (1 << 8), /* device supports HIPM */
+ ATA_DFLAG_DIPM = (1 << 9), /* device supports DIPM */
ATA_DFLAG_CFG_MASK = (1 << 12) - 1,
ATA_DFLAG_PIO = (1 << 12), /* device limited to PIO mode */
ATA_DFLAG_NCQ_OFF = (1 << 13), /* device limited to non-NCQ mode */
ATA_DFLAG_SPUNDOWN = (1 << 14), /* XXX: for spindown_compat */
+ ATA_DFLAG_SLEEPING = (1 << 15), /* device is sleeping */
ATA_DFLAG_INIT_MASK = (1 << 16) - 1,
ATA_DFLAG_DETACH = (1 << 16),
ATA_FLAG_ACPI_SATA = (1 << 17), /* need native SATA ACPI layout */
ATA_FLAG_AN = (1 << 18), /* controller supports AN */
ATA_FLAG_PMP = (1 << 19), /* controller supports PMP */
+ ATA_FLAG_IPM = (1 << 20), /* driver can handle IPM */
/* The following flag belongs to ap->pflags but is kept in
* ap->flags because it's referenced in many LLDs and will be
ATA_PFLAG_SUSPENDED = (1 << 17), /* port is suspended (power) */
ATA_PFLAG_PM_PENDING = (1 << 18), /* PM operation pending */
- ATA_PFLAG_GTM_VALID = (1 << 19), /* acpi_gtm data valid */
+ ATA_PFLAG_INIT_GTM_VALID = (1 << 19), /* initial gtm data valid */
/* struct ata_queued_cmd flags */
ATA_QCFLAG_ACTIVE = (1 << 0), /* cmd not yet ack'd to scsi lyer */
ATA_QCFLAG_IO = (1 << 3), /* standard IO command */
ATA_QCFLAG_RESULT_TF = (1 << 4), /* result TF requested */
ATA_QCFLAG_CLEAR_EXCL = (1 << 5), /* clear excl_link on completion */
+ ATA_QCFLAG_QUIET = (1 << 6), /* don't report device error */
ATA_QCFLAG_FAILED = (1 << 16), /* cmd failed and is owned by EH */
ATA_QCFLAG_SENSE_VALID = (1 << 17), /* sense data valid */
ATA_TMOUT_INTERNAL = 30 * HZ,
ATA_TMOUT_INTERNAL_QUICK = 5 * HZ,
+ /* FIXME: GoVault needs 2s but we can't afford that without
+ * parallel probing. 800ms is enough for iVDR disk
+ * HHD424020F7SV00. Increase to 2secs when parallel probing
+ * is in place.
+ */
+ ATA_TMOUT_FF_WAIT = 4 * HZ / 5,
+
/* ATA bus states */
BUS_UNKNOWN = 0,
BUS_DMA = 1,
ATA_EHI_RESUME_LINK = (1 << 1), /* resume link (reset modifier) */
ATA_EHI_NO_AUTOPSY = (1 << 2), /* no autopsy */
ATA_EHI_QUIET = (1 << 3), /* be quiet */
+ ATA_EHI_LPM = (1 << 4), /* link power management action */
ATA_EHI_DID_SOFTRESET = (1 << 16), /* already soft-reset this port */
ATA_EHI_DID_HARDRESET = (1 << 17), /* already soft-reset this port */
ATA_HORKAGE_BROKEN_HPA = (1 << 4), /* Broken HPA */
ATA_HORKAGE_SKIP_PM = (1 << 5), /* Skip PM operations */
ATA_HORKAGE_HPA_SIZE = (1 << 6), /* native size off by one */
+ ATA_HORKAGE_IPM = (1 << 7), /* Link PM problems */
+ ATA_HORKAGE_IVB = (1 << 8), /* cbl det validity bit bugs */
+ ATA_HORKAGE_STUCK_ERR = (1 << 9), /* stuck ERR on next PACKET */
/* DMA mask for user DMA control: User visible values; DO NOT
renumber */
unsigned long deadline);
typedef void (*ata_postreset_fn_t)(struct ata_link *link, unsigned int *classes);
+/*
+ * host pm policy: If you alter this, you also need to alter libata-scsi.c
+ * (for the ascii descriptions)
+ */
+enum link_pm {
+ NOT_AVAILABLE,
+ MIN_POWER,
+ MAX_PERFORMANCE,
+ MEDIUM_POWER,
+};
+extern struct class_device_attribute class_device_attr_link_power_management_policy;
+
struct ata_ioports {
void __iomem *cmd_addr;
void __iomem *data_addr;
struct scsi_device *sdev; /* attached SCSI device */
#ifdef CONFIG_ATA_ACPI
acpi_handle acpi_handle;
+ union acpi_object *gtf_cache;
#endif
/* n_sector is used as CLEAR_OFFSET, read comment above CLEAR_OFFSET */
u64 n_sectors; /* size of device, if ATA */
pm_message_t pm_mesg;
int *pm_result;
+ enum link_pm pm_policy;
struct timer_list fastdrain_timer;
unsigned long fastdrain_cnt;
#ifdef CONFIG_ATA_ACPI
acpi_handle acpi_handle;
- struct ata_acpi_gtm acpi_gtm;
+ struct ata_acpi_gtm __acpi_init_gtm; /* use ata_acpi_init_gtm() */
#endif
u8 sector_buf[ATA_SECT_SIZE]; /* owned by EH */
};
int (*port_suspend) (struct ata_port *ap, pm_message_t mesg);
int (*port_resume) (struct ata_port *ap);
-
+ int (*enable_pm) (struct ata_port *ap, enum link_pm policy);
+ void (*disable_pm) (struct ata_port *ap);
int (*port_start) (struct ata_port *ap);
void (*port_stop) (struct ata_port *ap);
extern void sata_print_link_status(struct ata_link *link);
extern void ata_port_probe(struct ata_port *);
-extern void __sata_phy_reset(struct ata_port *ap);
-extern void sata_phy_reset(struct ata_port *ap);
extern void ata_bus_reset(struct ata_port *ap);
extern int sata_set_spd(struct ata_link *link);
extern int sata_link_debounce(struct ata_link *link,
extern int ata_ratelimit(void);
extern int ata_busy_sleep(struct ata_port *ap,
unsigned long timeout_pat, unsigned long timeout);
+extern void ata_wait_after_reset(struct ata_port *ap, unsigned long deadline);
extern int ata_wait_ready(struct ata_port *ap, unsigned long deadline);
extern void ata_port_queue_task(struct ata_port *ap, work_func_t fn,
void *data, unsigned long delay);
/* libata-acpi.c */
#ifdef CONFIG_ATA_ACPI
+static inline const struct ata_acpi_gtm *ata_acpi_init_gtm(struct ata_port *ap)
+{
+ if (ap->pflags & ATA_PFLAG_INIT_GTM_VALID)
+ return &ap->__acpi_init_gtm;
+ return NULL;
+}
extern int ata_acpi_cbl_80wire(struct ata_port *ap);
-int ata_acpi_stm(const struct ata_port *ap, struct ata_acpi_gtm *stm);
-int ata_acpi_gtm(const struct ata_port *ap, struct ata_acpi_gtm *stm);
+int ata_acpi_stm(struct ata_port *ap, const struct ata_acpi_gtm *stm);
+int ata_acpi_gtm(struct ata_port *ap, struct ata_acpi_gtm *stm);
#else
+static inline const struct ata_acpi_gtm *ata_acpi_init_gtm(struct ata_port *ap)
+{
+ return NULL;
+}
static inline int ata_acpi_cbl_80wire(struct ata_port *ap) { return 0; }
#endif
/*
* EH
*/
-extern void ata_eng_timeout(struct ata_port *ap);
-
extern void ata_port_schedule_eh(struct ata_port *ap);
extern int ata_link_abort(struct ata_link *link);
extern int ata_port_abort(struct ata_port *ap);
* printk helpers
*/
#define ata_port_printk(ap, lv, fmt, args...) \
- printk(lv"ata%u: "fmt, (ap)->print_id , ##args)
+ printk("%sata%u: "fmt, lv, (ap)->print_id , ##args)
#define ata_link_printk(link, lv, fmt, args...) do { \
if ((link)->ap->nr_pmp_links) \
- printk(lv"ata%u.%02u: "fmt, (link)->ap->print_id, \
+ printk("%sata%u.%02u: "fmt, lv, (link)->ap->print_id, \
(link)->pmp , ##args); \
else \
- printk(lv"ata%u: "fmt, (link)->ap->print_id , ##args); \
+ printk("%sata%u: "fmt, lv, (link)->ap->print_id , ##args); \
} while(0)
#define ata_dev_printk(dev, lv, fmt, args...) \
- printk(lv"ata%u.%02u: "fmt, (dev)->link->ap->print_id, \
+ printk("%sata%u.%02u: "fmt, lv, (dev)->link->ap->print_id, \
(dev)->link->pmp + (dev)->devno , ##args)
/*